WeldCraft Jet

[gunner3006]

Flapper disk for the win. Heading to the welder for the bed mods lol. Then I’m going to hit it with the liner spray.

 

[High Velocity]

Yeah I was gunna let that one go lol.

Dual clamp tensioning screws should be 180* apart.

 

[gunner3006]

New throttle installed and hooked up. Pulled my window out to mount the two side bolts. Ripped my gasket . New gasket coming. Started making the doghouse more usable and into a bed when needed.

 

[gunner3006]

Almost ready for the line-x. Fit it up tomorrow then work on a bed system for it.

 

[gunner3006]

 

["The judge"]

So I decided to remove my kicker. I am putting a portable one on. If anyone is looking for wicked deal on a kicker I got one. Panther steering, all the controls and key of course. Sips the fuel. Power tilt as well. //uploads.tapatalk-cdn.com/20200316/9499e83425f46a69085dc9c9a3963c25.jpg

What size f kicker 9.9?? What length would f leg?? How much??

 

[neilsleder]

Totally looking for a kicker. But also looking for a job so kicker won’t be happening

 

[gunner3006]

Totally looking for a kicker. But also looking for a job so kicker won’t be happening

No worries buddy. I sold er. I loved that kicker. My problem with it was it was heavy. With hydraulic tilt and all the controls that made it not portable, I was ready for a change. So I’m going to a 6 hp merc or tohatsu. There actually the same motor. But we will see what pops up. I have to get the boat back up to sexsmith for a cover. Can see the light at the end of the tunnel now. Just need some nice weather.

 

[pfi572]

Told you it looked heavy ?!! Now the truth comes out ?

 

[Clode]

I have the new 6hp merc long leg for my boat. Its like 60 pounds and pushes my 20' Ali-craft with 2 people and 2 dogs at 4.7 mph wide open.

 

[Caper11]

Told you it looked heavy ?!! Now the truth comes out ?

Well it did say Yamaha on it.

 

[gunner3006]

I have the new 6hp merc long leg for my boat. Its like 60 pounds and pushes my 20' Ali-craft with 2 people and 2 dogs at 4.7 mph wide open.

Is it portable Clode? I don’t want mine on all the time.

 

[Clode]

Is it portable Clode? I don’t want mine on all the time.

yup, and the fuel tank is built in. you can get remote kits for it also

 

[gunner3006]

yup, and the fuel tank is built in. you can get remote kits for it also

https://cdn.shopify.com/s/files/1/2593/7250/products/mercury_6_hp.jpg?v=1563202615

This is the one I’m looking at right now.

 

[Clode]

This is the one I’m looking at right now.

I used it last summer, worked great for trolling, sips fuel, and is not super heavy

 

[gunner3006]

I used it last summer, worked great for trolling, sips fuel, and is not super heavy

Well that’s good to hear. I have the line for fuel that’s still run out to the kicker plate for the Yamaha from my main tank. It tilts up high enough when your driving ?

 

[Clode]

Well that’s good to hear. I have the line for fuel that’s still run out to the kicker plate for the Yamaha from my main tank. It tilts up high enough when your driving ?

with my Ali-craft outboard mount when I am in travel mode I swivel it onto the swim grid. The leg goes into a rubber v-block and I bungie cord it. It tilts a lot.

 

[gunner3006]

with my Ali-craft outboard mount when I am in travel mode I swivel it onto the swim grid. The leg goes into a rubber v-block and I bungie cord it. It tilts a lot.

Right on. We’re did you buy yours from? Was it new or used?

 

[Clode]

Right on. We’re did you buy yours from? Was it new or used?

new, from my local dealer Trail Blazin Power

 

[gunner3006]