WeldCraft Jet

[gunner3006]

If in and around the Leduc area before they go on I could tig that up for you! Might cost you a beer

Thanks Neil. I’m chapped cause I was down there back to back weekends.

 

[gunner3006]

Busy week here. Got the new engine in yesterday. Starting to put everything back together. Cleaning up the electrical with a new fuse block and terminal strips. Got the stereo installed today and it sounds pretty good. I pulled my cooler apart and cleaned it with a de-scaler I use for work. It wasn’t horrible but I try to flush my system at home every time I pull it out of the water. I ended up having a buddy tig up my riser. He wanted to take a shot at it and see what he could do. He’s not a welder but he did a pretty decent job. Remote oil filter also got installed today. Coolant is back in and I was able to get my engine pre-lubed. It’s coming together.

 

[gunner3006]

 

[NoBrakes!]

Good work man! Springs coming

 

[gunner3006]

It’s alive

 

[NoBrakes!]

looks good man! Head up to Taylor and take her for a chew!

 

[neilsleder]

How much hp did you go up? Looks good!

 

[gunner3006]

Just waiting for my pcv setup to show. Then it will be complete. As far as hp and torque it’s tough to say. Every chart and dyno I read is different. They there is the marine aspect. I think I’m safe to say pushing 350-375 ft/lb? The stroker was 440 I believe.

 

[NoBrakes!]

PCV right to flame arrestor no?

 

[gunner3006]

PCV right to flame arrestor no?

Yup I’m just running thru one of those fiber cups that I can clean out.

 

[NoBrakes!]

man it would be nice if the risers had a dry port for pan evac into the exhaust....

 

[gunner3006]

Got this bad boy installed today and lines run. Also got my diesel heater mounted. Just waiting for the new fuel tank to be built.

 

[Chrisco]

//uploads.tapatalk-cdn.com/20200228/328892beb784f7c5288c89f4ecd7ee74.jpg


It’s alive

That looks great man !!! that extra length in them 2 plug wires is bothering me lol.

 

[pfi572]

That looks great man !!! that extra length in them 2 plug wires is bothering me lol.

What about the screw clamps on exhaust ? Jeesh

 

[gunner3006]

What about the screw clamps on exhaust ? Jeesh

Man that’s what was on there. And we’re those exhaust pipes a bitch to get off. Whoever fitted them did it tight.

 

[NoBrakes!]

What about the screw clamps on exhaust ? Jeesh

I have run a few lightings into hose with no clamps, what do you use?

 

[pfi572]

Man that’s what was on there. And we’re those exhaust pipes a bitch to get off. Whoever fitted them did it tight.

LOL

 

[NoBrakes!]

oh I see... anal

 

[pfi572]

oh I see... anal

Just hacking on Chadd .
Looks awesome

 

[Chrisco]

Just hacking on Chadd .
Looks awesome

lol yes like i said looks wicked.