Riser

[plio7]

Ok so my buddy has a 2003 summit and can't get the riser to tighten enough that the bars won't swivel.... Tried tightening, putting in rubber and tightening more, putting screws through to lock it, but this phucking thing won't tighten down enough to keep the bars from tilting...... Is this a stock skidoo steering post? Because he bought a different riser off of echo marine and the holes didn't line up

138045[/ATTACH]

 

[snopro]

If its an X I believe so Plio.

 

[Bnorth]

Coat the parts that mate in red loctite.

 

[02 summit 700]

in pic 2 i can see in the top left corner the the block holding the pivot tube is broke right in half theres your problem and it looks like the other one is snapped also over tightened it ??

 

[lshobie]

Powermadd pivot riser and rised, they never move on me.

 

[Barker]

I agree with 02 summit 700 there should be a gap between the cap and its mate, and looks broken!

 

[Rstone]

my 01 has a powermadd pivot adapter and pivot riser block it works good never had a problem with them coming loose

 

[Barnes]

When i picked up my sled off Teth-air, this was another one of those things that was broken. Had to replace the two caps because they were cracked. I think it ran me about $40 or more. Check with the dealer

 

[CUSO]

You have to be careful with this add on-to-plate system.

the weakest link is the factory steering post plate on the underside. I would weld gussets under it, because I broke mine high up in westridge.. NOT fun coming down with a handlebar that is barley held on with cracked welds..

 

[Summitric]

Yup, looks like the picture in the top right, the hold down is broken in half...... That will be your problem.