M1000 Chassis

[Doctor Mud]

Hey guys, I need some technical advice. I have a 2008 M1000 with a screwed bulkhead and tunnel. I have found a used bulkhead and tunnel of a 2007 M7. Will this tunnel and bulkhead work with my M1000?

Thanks!

 

[cnelson6]

I don't think it will because the pto side has only two spots for the engine mounts and the one for the Mag side where the m1000 has three on the pto and and one on the mag side but the Mag side is off a bracket on the rear of the bulkhead. There is a used one on kijiji calgary full tunnel and everything. Take a look at that.

 

[moyiesledhead]

Won't work without motor mount modification. Hole for the Diamond Drive won't match either.

 

[KatMan]

wild,

why so many changes in one year? did the 07 have that many issues? Motor movement issues? i go through one belt a season, count that cost of doing buisiness.

 

[moyiesledhead]

Just re-read your post. Got hung up on the M7 part. Can't be a bulkhead for a 2007 M7.....they didn't make them past 2006. If it's a 2007 M8 or M1000 bulkhead it will work.

 

[Team Pigeon]

If the used bulkhead is from an m7, no worky.
Production of the m7 ended in 2006.

Production of the m8 started in 2007. It should fit.

What were trying to tell you is that there's no such thing as a 2007 m7.