1994 PHAZER 2 LE PROJECT

NoBrakes!

Active VIP Member
Joined
Nov 13, 2011
Messages
6,358
Reaction score
12,967
Location
Edmonton
To adjust the cable back off the adjusters at the carb plungers and at the choke lever there should be some free play. The free play is checked when the choke is in the off position and you lightly pull out on the piece that the lever attaches to. Do not flip the choke lever at all, leave it in the off position. With the choke adjuster nuts backed off you should be able to pull this out quite a bit until resistance is felt. That resistance is the plunger starting to lift and the spring above the plunger compressing. You only want to be able to pull the cable out to about 2-3mm of free play. I will adjust one at a time, you will be able to feel the reduced free play as you go. When I feel the change initially I stop and adjust the other side until I feel it starting to take up some free play. Then adjust both slowly until the 2-3mm is achieved. I then confirm the choke operation with fluid at the closed position.
Thank you sir! I will check the choke cables, compression and spark... stay tuned!
 

NoBrakes!

Active VIP Member
Joined
Nov 13, 2011
Messages
6,358
Reaction score
12,967
Location
Edmonton
Are the TORS wires still plugged in? These are yamahas throttle safety switch. They cause lots of issues.
the ones from the motor are plugged into itself, but I will double check both ends
 

NoBrakes!

Active VIP Member
Joined
Nov 13, 2011
Messages
6,358
Reaction score
12,967
Location
Edmonton
90 PSI IN BOTH HOLES... she needs rings... looking like a project for after the bung bung now...
 

Clode

Active VIP Member
Joined
Jan 8, 2012
Messages
29,589
Reaction score
46,684
Location
BC
90 PSI IN BOTH HOLES... she needs rings... looking like a project for after the bung bung now...
Thats too bad, when you have it apart its worth knife edging the transfer divider at the bottom, they are completely blunt, horrible for flow. If it still has the steel reeds put a set of Boysen reed petal kits it it. If it needs piston for overbore don't use Wiesco, go with a good cast piston like Pro-x. The Wiesco just grow too much in the fan cooled units unless you give them extra clearance, and in my opinion it not worth it.
 
Top Bottom