Vacation Property House Plans

ferniesnow

I'm doo-ing it!
Joined
Dec 2, 2008
Messages
112,494
Reaction score
86,556
Location
beautiful, downtown Salmon Arm, BC
Im trying to figure out the bylaws for the lots,

Here is my info package, Trying to figure out how much area is required on both sides of property lines. on east and west side of property. The lot is 65'5" x 115 long. The bylaws are in the document, page# 39 of 116 there's not 116 pages. I see I must go above 1001 sq/ft with max height of 30M.

View attachment 232470

Did you find a definition of interior side and exterior side yards? The set backs seem pretty standard; 19.68' in the front and rear, 6.56' on the interior side, and 9.84' on the exterior side. Maximum height is 32.8' for the residence and 11.48' for an accessory building.
According to my calculations, you can build a house with a maximum of 49' across the front and 75.63' from the back to the front not taking into anything for lot/setback percentages which I didn't see.

I would b a little concerned about the height of the accessory building at 11.48' maximum. That would be 9' walls with (more or less) a 1'deep truss system with minimal slope. Looks like you will need and attached garage.
 

rknight111

Administrator
Administrator
Moderator
Joined
Sep 27, 2006
Messages
13,703
Reaction score
23,489
Location
Parkland County, AB and Valemount, BC
Website
www.snowandmud.com
Did you find a definition of interior side and exterior side yards? The set backs seem pretty standard; 19.68' in the front and rear, 6.56' on the interior side, and 9.84' on the exterior side. Maximum height is 32.8' for the residence and 11.48' for an accessory building.
According to my calculations, you can build a house with a maximum of 49' across the front and 75.63' from the back to the front not taking into anything for lot/setback percentages which I didn't see.

I would b a little concerned about the height of the accessory building at 11.48' maximum. That would be 9' walls with (more or less) a 1'deep truss system with minimal slope. Looks like you will need and attached garage.

Thanks Doug. I may go with the one with the garage on a portion of the lower level and flip the interior around so that all my living room, kitchens face the back which looks on to canoe mountain. Then I can put a patio door out there to a back deck.
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,561
Reaction score
56,433
Location
Leduc
Are you required to use fire protected plywood?
 

Cableguy

Active VIP Member
Joined
Dec 16, 2014
Messages
2,137
Reaction score
5,076
Location
Okanagan
confirm your setbacks are to exterior walls and not roofline
some districts have weird wording this
 

TROLLCAT

Active VIP Member
Joined
Nov 23, 2010
Messages
71,609
Reaction score
39,492
Location
Dease Lake BC
go with honomobo

they make some nice sea-can's

sorry not sure how to post a link
 

rknight111

Administrator
Administrator
Moderator
Joined
Sep 27, 2006
Messages
13,703
Reaction score
23,489
Location
Parkland County, AB and Valemount, BC
Website
www.snowandmud.com
go with honomobo

they make some nice sea-can's

sorry not sure how to post a link

Those are pretty strange buildings, not my type and they would not fit the neighborhood, they look nice on the inside but just a bunch of boxes, and they charge an arm and a leg for them. Here's the link https://www.honomobo.com/ca/home
 

rknight111

Administrator
Administrator
Moderator
Joined
Sep 27, 2006
Messages
13,703
Reaction score
23,489
Location
Parkland County, AB and Valemount, BC
Website
www.snowandmud.com
Did you find a definition of interior side and exterior side yards? The set backs seem pretty standard; 19.68' in the front and rear, 6.56' on the interior side, and 9.84' on the exterior side. Maximum height is 32.8' for the residence and 11.48' for an accessory building.

It would be both interior sides as I have houses on both sides, exterior is if there is no house next door. Lots of room. Sean is drafting me up plot plan with a box where the largest footprint can be. based on the bylaws provided.
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,561
Reaction score
56,433
Location
Leduc
confirm your setbacks are to exterior walls and not roofline
some districts have weird wording this

Leduc changes that on each sub division. They seem to like zero lot lines.
 

skidoo6100

Active member
Joined
Jan 9, 2010
Messages
124
Reaction score
125
Location
Stony Plain
My wife is an architectural drafts person who works for the largest drafting company in Edmonton, if your looking for custom plans we could help you out.
 

rknight111

Administrator
Administrator
Moderator
Joined
Sep 27, 2006
Messages
13,703
Reaction score
23,489
Location
Parkland County, AB and Valemount, BC
Website
www.snowandmud.com
For the Garage, Would be a 24 x 24 size with 10' door be good for pulling in with a deck. Chev 1 ton with deck, not lifted.

Found an Draftsperson in Kamloops and have him drafting me up a floor plan.
 
Last edited:

skegpro

Active VIP Member
Joined
May 11, 2009
Messages
9,930
Reaction score
21,329
Location
In them hills.
Anyone know of decent local home plan consultants/draftsman in Edmonton?


I like that one with the garage below as well but when doing this with a 9 or 10’ garage door then have to go up a pile of stairs to get in every time. Not sure if this is a good resale plan, good for me while I’m still not all crippled up with sore legs, hips and back. If you want to have this as a relaxing retirement vacation retreat is a place like this right to build?
These guys were unreal to work with.
7eb303ad4293fe29b8e668a82608d96d.jpg
 

Luke The Drifter

Active VIP Member
Joined
Dec 29, 2008
Messages
1,512
Reaction score
2,768
Location
Parkland County
For the Garage, Would be a 24 x 24 size with 10' door be good for pulling in with a deck. Chev 1 ton with deck, not lifted.

Found an Draftsperson in Kamloops and have him drafting me up a floor plan.

What length of deck? Short box or long box? It’d be pretty tight with 24ft depth IMO.
 

tejay

Active VIP Member
Joined
Dec 20, 2010
Messages
2,067
Reaction score
8,351
Location
stoke
Silverado 3500 HD is 266” , add a sled on a deck ????
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,561
Reaction score
56,433
Location
Leduc
24 x 24 garage will be very tight. Plan on larger. Usually the biggest complaint on homes,,

Wish we built a larger garage.

Are you adding a floor drain in the garage?
 

TylerG

Super Mod Geek
Administrator
Moderator
Joined
Nov 7, 2006
Messages
31,479
Reaction score
29,336
Location
Parkland County
For the Garage, Would be a 24 x 24 size with 10' door be good for pulling in with a deck. Chev 1 ton with deck, not lifted.

Found an Draftsperson in Kamloops and have him drafting me up a floor plan.

you'll have no room for a work bench or anything in the garage at that size Ron..... I'd go 24x30 or 30x30 if you can.
 

bobsledder

Active VIP Member
Joined
Jan 11, 2009
Messages
2,840
Reaction score
6,142
Location
Not Sure
24 x 24 garage will be very tight. Plan on larger. Usually the biggest complaint on homes,,

Wish we built a larger garage.

Are you adding a floor drain in the garage?
14
so true. When home shopping that was on my list. Tell realtor to measure garage. Wouldn't go look if it was to small. Built my present home with 26 x 40, 14 ft wall 10 ft door Not big enough.

Maybe they are never big enough?
 

rknight111

Administrator
Administrator
Moderator
Joined
Sep 27, 2006
Messages
13,703
Reaction score
23,489
Location
Parkland County, AB and Valemount, BC
Website
www.snowandmud.com
Build the biggest garage the bylaws will allow IMO.

This would be great however this is only a vacation/cabin property and not a principal residence. I was hoping that those days that you drive and it’s colder that you can just pull into garage for the night with deck on truck with sleds. It may be a big expense to build a large high garage and not worth the return for a couple days to park the truck in the garage. May just pull the sleds off the deck and leave in garage. Same with side by side. Also if I make the door 10’ I have to make a lot of modifications to the house as well according to draftsman. 9’ ceilings are one to make it all work with the said floor plan
 
Top Bottom