Thinking of fabbing a belly pan dump instead of tunnel dump. TSS

cheeky24

Active member
Joined
Aug 12, 2014
Messages
86
Reaction score
14
Location
castlegar
Hey guys so I've started the install on my 13 xm. I bought a TSS liquid to air turbo kit and I,m going to be honest I really really don't want to hack a 3 inch hole in the tunnel of my very clean well keep sled. So i took a real good look at it and I sure I have enough room to fab up a belly dump exhaust tip. My question is has anyone out there done this and if not do any of you think this will screw up the performace of the kit.
 

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
17,005
Location
Leduc Alberta
Hey guys so I've started the install on my 13 xm. I bought a TSS liquid to air turbo kit and I,m going to be honest I really really don't want to hack a 3 inch hole in the tunnel of my very clean well keep sled. So i took a real good look at it and I sure I have enough room to fab up a belly dump exhaust tip. My question is has anyone out there done this and if not do any of you think this will screw up the performace of the kit.

I am with you you! I would want to hack a hole through the tunnel either. I can't see this hurting the performance. Is there room to go out the front like aerocharger kit?


Sent from my iPhone using Tapatalk
 

cheeky24

Active member
Joined
Aug 12, 2014
Messages
86
Reaction score
14
Location
castlegar
No it would have to go out the rear basically a tight 90 and right out the bottom.
 

Dannyturbo

Active VIP Member
Joined
Jan 5, 2013
Messages
314
Reaction score
594
Location
Valemount
As long as the pipe is a similar design with minimal back pressure then I can't see it hurting


Sent from my iPhone while drinkin a bud light
 

maierch

Active VIP Member
Joined
Oct 26, 2008
Messages
1,565
Reaction score
2,512
Location
Calgary
I was just talking to Dave about this last night at the sled show. The reason they went to a tunnel dump on the conventional kit is because when you get in the deep stuff the stock port can plug off and cause bogging. Especially with the 2.5" pipe. On the instaboost they have upped the diameter to 3" and went back to going out the stock port with no problems.
 

Dannyturbo

Active VIP Member
Joined
Jan 5, 2013
Messages
314
Reaction score
594
Location
Valemount
Yea you will literally have zero snuff issues with the tunnel dump


Sent from my iPhone while drinkin a bud light
 

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
17,005
Location
Leduc Alberta
It wasn't on a turbo but my cousin has a tunnel dump can on his xm, and we where in vale last year with crazy deep powder and his sled wouldn't run. It was like there was to much snow up inside the tunnel. The next day he had a mbrp can on and ran good.


Sent from my iPhone using Tapatalk
 

cheeky24

Active member
Joined
Aug 12, 2014
Messages
86
Reaction score
14
Location
castlegar
Well I said screw it and just drilled the hole, it hurt and there may have been a few tears but it's done. LOL
 

Attachments

  • IMG_4650.JPG
    IMG_4650.JPG
    98.4 KB · Views: 216

1100

Active VIP Member
Joined
Sep 7, 2008
Messages
1,232
Reaction score
1,745
Location
sangudo
Looks like I'm to late. But seen a few boondocker kits run out the side by the footwell through the side panel
 

fredw

Active VIP Member
Joined
Jan 15, 2010
Messages
3,317
Reaction score
3,586
Location
medicine hat
Never had a issue with exhaust out bottom of shock tower in front... is there any issues with ice buildup on tunnel dump??
 
Top Bottom