barefooter
Active VIP Member
have any been delivered yet? I have on on hold at martin's.
Looks like from Dootalk a few US dealers have them....
Looks like from Dootalk a few US dealers have them....
T Motion Kit
- Thread starter barefooter
- Start date
takethebounce
Active VIP Member
They are available and shipping to the dealers. There is a good supply but it will be tough to get them as the season goes on.
snopro
Active VIP Member
My dealer says they are backordered till Oct 5th?
takethebounce
Active VIP Member
That is a technicality. 
They are shipping though.
Sent from my HTC-Z710a using Tapatalk 2
They are shipping though.
Sent from my HTC-Z710a using Tapatalk 2
snopro
Active VIP Member
That is a technicality.
They are shipping though.
Not sure what you mean by that. Are they shipping "now" or shipping for an Oct 5th delivery date? And how do you know?
takethebounce
Active VIP Member
That is a technicality.
They are shipping though.
Not sure what you mean by that. Are they shipping "now" or shipping for an Oct 5th delivery date? And how do you know?
I was told they are now backordered to end of Oct this past week for anyone ordering now(dealer). But, was also told that some are expected by Oct 5th (mutilple dealers). So I took that as they are shipping now (yes for Oct 5th). Also a BRP rep (not dealer) mentioned the kits were shipping a few days ago but lots have been ordered so anyone ordering later would not be guaranteed to get one.
geash as if I ever give bad info! haha, maybe a little BS here and there
Last edited:
takethebounce
Active VIP Member
My t-motion kit came in last week, Sep 28th.
thorrider11
Active member
How much are these kits going for ? What all do they come with?
about 380 with tax.
As far as I can see, it comes with rear scissor, front arm, rear inboard kit, limiter strap, throttle rods, and upper idlers.. and lots of nuts and bolts/
I'll take a pic. gimme a minute.
As far as I can see, it comes with rear scissor, front arm, rear inboard kit, limiter strap, throttle rods, and upper idlers.. and lots of nuts and bolts/
I'll take a pic. gimme a minute.
Last edited:
the_real_wild1
Active VIP Member
But even with the kit dont you need to do something with the track to be effective? If it works I will buy one but I think I will wait until a few people have installed them and have some miles on them first. I dont think I have the cash right now anyways LMAO.
flabbajabba
Active VIP Member
Do you have 08 shocks in there? I wanted to do the T-motion but I thought you had to upgrade the shocks to match the longer ones? I was thinking the extreme air vents upgrade with T-motion when I do it?
Probably, It didn't say anything about it in the instructions. It does however say 2008 to 2012 models, specifically. Will see,
oler1234
Active VIP Member
cuso you have a 08 with 08 shocks? if so let us know how it works out. be hard to tell on the concrete in your floor but you never know, goal would be to pull over with 1 hand like the xm's
Oler,
Yes it's all pretty much stock except for the inboard wheels, and sit sag reducer.
I don't see how it wouldn't work, since the 2010 skid upgrade was the strap, shock, and rails with new holes for the longer shock. Suspension arms should be the same. I probably will do the extreme air vents upgrade AFTER.
Yes it's all pretty much stock except for the inboard wheels, and sit sag reducer.
I don't see how it wouldn't work, since the 2010 skid upgrade was the strap, shock, and rails with new holes for the longer shock. Suspension arms should be the same. I probably will do the extreme air vents upgrade AFTER.
takethebounce
Active VIP Member
I rode a 2012 last winter that had the tmotion without a flex track. It was noticeably easier to get on edge.
The flex track just adds that extra give for set up snow.
When I had taken my kit home I went through the bag of parts. I ended up with 4 extra flange nuts but was missing 2 8mm bolts. I will have to look at the directions to see where and what exactly is missing and if it is just a reused bolt.
Sent from my HTC-Z710a using Tapatalk 2
The flex track just adds that extra give for set up snow.
When I had taken my kit home I went through the bag of parts. I ended up with 4 extra flange nuts but was missing 2 8mm bolts. I will have to look at the directions to see where and what exactly is missing and if it is just a reused bolt.
Sent from my HTC-Z710a using Tapatalk 2
thegeneral
Active VIP Member
I have an odd request. I have a 2012 163 for sale. I want to keep the 3" track and drive shaft to put in the new XM. Is there anyone that's willing to give me their 2.5 track and stock drive shaft so I can sell/trade my sled and I'll give them the stock drive shaft and flex track when I get the XM home
Similar threads
