Skidoo xm problem thread..........

[Nitrobkr]

Picked mine up nov.30th.
Left side won't stay in...


Sent from my iPhone using

 

[tex78]

There is a new latch and stud.

Have mine ordered under warranty allready.

sent while I should be drinking twisted teas

 

[snopro]

There is a new latch and stud.

Have mine ordered under warranty allready.

sent while I should be drinking twisted teas

There we go! Thanks Tex. Now were getting somewhere.

 

[kyle019]

My left side won't stay in as well. Could be wrong but I'm sure I read somewhere that you can adjust the middle plastic piece around the gas cap and that's also a fix.. Any more info on that?

 

[neilsleder]

Mines been flipped around and hasn't came undone yet!

 

[Rust]

Yeah the left side on mine wouldn't stay shut. Spun the white washer and its pretty tight but stays shut. Left the right side alone as it stays shut the way it was.


Sent from my iPhone using

 

[ZIG]

i bought the washer from a 2013 summit that is black and now it works perfect.

 

[T-team]

What the hell is everyone talking about? Lol jk

 

[andrew3399]

What the hell is everyone talking about? Lol jk

They are talking about the superior fit and finish of doos. Lol.

 

[snopro]

I thought only Doo guys read this thread.....

 

[thegeneral]

They are talking about the superior fit and finish of doos. Lol.

That's a great way to put it. Doesn't sound like anything that would ruin a day in the hills


Thegeneral

 

[maxwell]

What are these panels (doors) you guys speak of. Mine are hanging in a tree somewhere


Sent from my iPhone using Tapatalk -

 

[tex78]

Ya I cut my knee and pants on the corner where it wasn't latched.

Checked into it.

I'll find the part # for u guys.


sent while I should be drinking twisted teas

 

[snopro]

What are these panels (doors) you guys speak of. Mine are hanging in a tree somewhere


Sent from my iPhone using Tapatalk -

There's a story I'd like to hear. Lol.

 

[drew562]

I put the little grommets from a 2013 in my 14 xm. On my freeride I turned the little grommets upside down and they are super tight. No more opening panels.

 

[tex78]

Here's the part #'s from doo talk

sent while I should be drinking twisted teas

 

[tex78]

Here it is

sent while I should be drinking twisted teas

 

[Chuck87]

anyone else seem like they have a good vibrating through there feet (2014 800 sp 146) tighted my track belts fine but still a descent vibration

 

[dropitbuster]

Check the underside of your rave valve cover right above the y-pipe. All 3 of the XM's in our group have melted a hole in them allowing belt dust etc to gum up the raves. It's easy to get to if you just take off your clutch guard. Dealer says it could be caused by not enough cool air getting in the engine compartment if you have the pre-filter screen in the nose. I put some foil heat tape on the cover. We'll see if it holds up.

 

[tex78]

That's one of the first things I did, was heat taped the rave cover

13's had the same thing, didn't figure it was any different to a 14

sent while I should be drinking tea's