New factory short block?

Barnes

Active VIP Member
Joined
Oct 12, 2010
Messages
214
Reaction score
43
Location
Morinville
I'll be honest with you, my sled engine is still sitting in the basement, with the puller kit sitting next to it. Too much ch!t going on at work to even deal with this, let along come on snow and mud. I'm surprized i noticed this. We'll see how the next few weeks go before i head outta town for a while.
 

imdoo'n

Active VIP Member
Joined
Jan 15, 2008
Messages
58,426
Reaction score
51,885
Location
alberta from the back porch
lots of quiet, someone not truthful at all. by the condition of motor shown, buyer didn't take very good care of motor, oil from exhaust everywhere. looked bagged. who is telling truth? serial #'s can be traced.

if i were barnes, i'd not be waiting around.
 
Last edited:

bobsledder

Active VIP Member
Joined
Jan 11, 2009
Messages
2,830
Reaction score
6,126
Location
Not Sure
lots of quiet, someone not truthful at all. by the condition of motor shown, buyer didn't take very good care of motor, oil from exhaust everywhere. looked bagged. who is telling truth? serial #'s can be traced.

if i were barnes, i'd not be waiting around.
it was a new shortblock, he says so on utube so it has to be right?
 

KVF 700

Active VIP Member
Joined
Mar 6, 2009
Messages
883
Reaction score
105
Location
Woking
lots of quiet, someone not truthful at all. by the condition of motor shown, buyer didn't take very good care of motor, oil from exhaust everywhere. looked bagged. who is telling truth? serial #'s can be traced.

if i were barnes, i'd not be waiting around.

Well a loose y pipe will cause oil to be everywhere so I don't know if I would consider that to be bagged... Just not cleaned
 

Barnes

Active VIP Member
Joined
Oct 12, 2010
Messages
214
Reaction score
43
Location
Morinville
I'm going to assume the cracked carb boot that was on that side was the cause of the lean out... thus exploding that cylinder.
 

skegpro

Active VIP Member
Joined
May 11, 2009
Messages
9,930
Reaction score
21,329
Location
In them hills.
Holy Chit that was a long one....

Maybe the roomate that borrowed the sled blew up the "New Short block" then proceded to downtown Valemount and purchased a back alley jb weld special from behind the Palace.........

I doubt a military man would lie .........

But I also doubt that Teth-Air is that hard up for money that he would Lie about it being a new short block .........

Fun Fact: If everyone that viewed this thread gave Barnes a toonie, he'd have a new etech by now....crazy amount of air time.

Lets see the inside of that block Barnes......
P.S don't lend the roomate your Chit.
 

imdoo'n

Active VIP Member
Joined
Jan 15, 2008
Messages
58,426
Reaction score
51,885
Location
alberta from the back porch
Holy Chit that was a long one....

Maybe the roomate that borrowed the sled blew up the "New Short block" then proceded to downtown Valemount and purchased a back alley jb weld special from behind the Palace.........

I doubt a military man would lie .........

But I also doubt that Teth-Air is that hard up for money that he would Lie about it being a new short block .........

Fun Fact: If everyone that viewed this thread gave Barnes a toonie, he'd have a new etech by now....crazy amount of air time.

Lets see the inside of that block Barnes......
P.S don't lend the roomate your Chit.

yes, i agree, just to many unanswered ?'s. can that motor # be traced? who do you believe?
 

skegpro

Active VIP Member
Joined
May 11, 2009
Messages
9,930
Reaction score
21,329
Location
In them hills.
yes, i agree, just to many unanswered ?'s. can that motor # be traced? who do you believe?

As a small business owner Teth-Air has nothing to gain by treating customers poorly .......I havn't been on this site as long as most of you but I think we have to give the man some street credit here.

I know if my sled ch!t the bed, I would be pullin all nighters trying to figure out exactly what went wrong.

To many holes in this story....
 

skegpro

Active VIP Member
Joined
May 11, 2009
Messages
9,930
Reaction score
21,329
Location
In them hills.
takes like ten mins to undoo the bolts to split the block...just sayin

Especially being a professional mechanic ……

And the last time I checked being a mechanic in the military was a government job so how busy can he really be ……..
 

kimrick

RIP Fellow Sledder
Joined
Nov 28, 2009
Messages
2,236
Reaction score
6,304
Location
In Heaven & Revelstoke
Holy crap did I miss alot on this thread in a couple days....

Lots of know it alls going on though!


Go buy a new short block and say "I can make this sled mine"

So sad for your lose, but think of what you will have after a 4 grand upgrade with clutch, reeds etc.


Just blow the doors of the boys after that!!!!

Good luck with your new build.
 
Top Bottom