IGBT
Active member
I got the diamond drive upgraded to a 3203 bearing, cleaned out and installed back in my 2011 M8 SnoPro 153.
Everything looks good, but I am having the hardest time getting the track alignment perfect. What looks good when I let the track coast to a stop on the stand changes when I tighten down the axle bolts (the bolts through the idlers). It seems like the right side rear idler is about 1/16" from the outer track drive lug and about 3/16" from the inner track drive lug. The other idler is closer to 1/8" from either lug.
Is this good enuf? The idler doesn't seem to be actually rubbing on the lugs, but it is very close.
Or should I try to adjust it for the 11th time?
Everything looks good, but I am having the hardest time getting the track alignment perfect. What looks good when I let the track coast to a stop on the stand changes when I tighten down the axle bolts (the bolts through the idlers). It seems like the right side rear idler is about 1/16" from the outer track drive lug and about 3/16" from the inner track drive lug. The other idler is closer to 1/8" from either lug.
Is this good enuf? The idler doesn't seem to be actually rubbing on the lugs, but it is very close.
Or should I try to adjust it for the 11th time?