Engine code, Low Chassis Voltage

Teth-Air

Active VIP Member
Joined
Oct 16, 2008
Messages
3,785
Reaction score
8,085
Location
Calgary/Nelson
So I had a low chassis voltage code pop up on my 14 Pro this weekend. It still ran okay but I dropped it at dealer to see what's up.

Anybody else have this?

Symptoms: Yellow Engine light flashing and a picture of a battery comes up on gauge even though it is manual start.

With brake applied, hit set button and 2 numbers pop up, 167 and the number 4 ( I think it was) anyway manual says that is low chassis voltage.

As the headlight is still bright and runs on AC, I assume the problem may be a bad connection or a pending voltage regulator failure.

Anybody been through this?
 

rmscustom

Active member
Joined
Jun 29, 2013
Messages
142
Reaction score
101
Location
all over
Same thing going on with mine. Swapped VRs no change. I've heard it could be stator, fuel pump going bad or as simple as idling to low. Soon as I touch the throttle mine goes away so I'm hoping its low idle.
I've also gone through my connections and grounds with no change. Post what the dealer finds. Thanks
 
Last edited:

SavageCanuck

Active VIP Member
Joined
May 25, 2009
Messages
687
Reaction score
536
Location
Kelowna
Could be a wire rubbing thru.It happened at about 100 miles on my 14.Mine had the dash lights flickering.There is also a chassis ground that could be bad.I have had more than a few gremlins with my 2014.Its ready too be picked up from a bad bog due to a warped throttle block throwing TSS codes.When they throw a code its much easier for them
 
Top Bottom