Well i installed a xt2500lb warn winch today on the 500 reneagade. Everytime i go to use the winch, i spoll it out and as soon as i let go of the button the quad quits. After about 2-3mins the relay will reset itself and i spool it in it still is the same. After letting the quad run for a while it acc worked for a couple of times. Is it a voltage problem in the computer that makes it shut down or not.
Ele problems after installing winch
- Thread starter grizzley1
- Start date
AreWeThereYet
Active VIP Member
Might be a voltage problem,.. rev the quad up to around 3000-4000rpm and trying it. If it helps, and the quad wants to stay running, you might be able to get a higher CCA battery, or increase stator output with an aftermarket one.
Also make sure your power and ground cables are as short as possible running to the relay from the battery
Also make sure your power and ground cables are as short as possible running to the relay from the battery
Similar threads
