850 died on trail in WTF?

Big A

Active VIP Member
Joined
Oct 27, 2008
Messages
327
Reaction score
1,037
Location
Rocky Mtn House
So my ‘17 g4 wasn’t idling the best when I loaded to head out to Golden but I just figured it’s been sitting in my shop for a month, no big deal, it’ll clean up. Get to silent pass parking lot on Friday, sun was shining, gonna be a great day I figure. Sled fires up first pull, idles for a minute then dies. Fire up again, idles for five minutes, dies again, fire up third time, burn around parking lot for a bit, seems fine, good to go. Get on trail, running great, trail is super smooth, cruising along at 90-100km/hr and it died like somebody hit the kill switch, wtf, check connections on everything, pull the ignorant pos hood off, found no issues. Fkn thing will not start. Finally fires but only runs on one. Get TOWED back by my buddies cat ?, spend rest of day in parking lot trying to diagnose while buddies rode. Called a few dealers and no real suggestions other than maybe spark plugs, cmon, fk me, it was running fine down the smooth trail, plugs don’t just magically foul at 7000rpm, or possibly a piston, but with only 850k on it I hope not. Sled is equipped with a redline low boost kit but since Dave’s controller just adds fuel in proportion to boost and I was barely pulling any boost on the flat trail, highly doubt its turbo related. Kit was installed roughly 150km ago. Last trip out also had knock sensor issues but made repair on the hill and didn’t seem to be an issue any longer.
Suggestions??
 

Big A

Active VIP Member
Joined
Oct 27, 2008
Messages
327
Reaction score
1,037
Location
Rocky Mtn House
Forgot to mention, checked for codes and was showing “no codes found”
 

TDR

Active VIP Member
Joined
Dec 19, 2012
Messages
935
Reaction score
1,395
Location
Edmonton
Had a buddy with a 17 had a stator or ignition coil crap the bed when it was new. Same thing you described cruising and someone hit the kill switch.
 

skegpro

Active VIP Member
Joined
May 11, 2009
Messages
9,930
Reaction score
21,329
Location
In them hills.
Had a buddy with a 17 had a stator or ignition coil crap the bed when it was new. Same thing you described cruising and someone hit the kill switch.
My money is on a broken ignition coil wire too.

Stators either work or they don't.

Imo
 

Skidoomiles

Active member
Joined
Jan 23, 2012
Messages
89
Reaction score
107
Location
Edmonton
Tell your dealer to call BRP, it may be a RFID module. Talk to Martin Motorsports, they have experienced this. It is a module that has something to do with the key communicating with the computer.
 

Jsymes

Active VIP Member
Joined
Jan 8, 2014
Messages
236
Reaction score
454
Location
Alberta
Check the injector wires they've been zip tied too tight and have been pulling out or breaking off on the 17s
 

Big A

Active VIP Member
Joined
Oct 27, 2008
Messages
327
Reaction score
1,037
Location
Rocky Mtn House
I had it in to turps to get the injector updates done so shouldn’t be that. I didn’t do a compression test yet but seemed Electrical the way it just died, thanks for the tip on tue rfid
 

snopro

Active VIP Member
Joined
Mar 3, 2009
Messages
108,864
Reaction score
105,917
Location
Milo,Alberta
I hate to be a Debbie Downer but take into account that once a dealer plugs into your sled on BUDS you are on borrowed time for any warranty work down the road if someone at BRP chooses to look at any BUDS files on your serial number. They killed the warranty on a customer's sled of ours that had ran a turbo and then removed it after his motor blew and they had looked at his BUDS history report. They saw the air intake numbers were through the roof and immediately killed all his extended warranty even after we offered to send them pics of the sled in the shop. Just a heads up guys for your information.
 

Alpine_Bound

Active member
Joined
Dec 6, 2009
Messages
111
Reaction score
300
Location
Sparwood, BC
I had an issue with shorted grip heaters that was somewhat similar to your situation. You can try disconnecting them to rule it out. Connector for them is under the hood on the right hand side, there is a group of three grey connectors. I believe it was the middle one in the group. Keep in mind when you disconnect the plug your kill switch will no longer shut the engine down.
 

Big A

Active VIP Member
Joined
Oct 27, 2008
Messages
327
Reaction score
1,037
Location
Rocky Mtn House
I hate to be a Debbie Downer but take into account that once a dealer plugs into your sled on BUDS you are on borrowed time for any warranty work down the road if someone at BRP chooses to look at any BUDS files on your serial number. They killed the warranty on a customer's sled of ours that had ran a turbo and then removed it after his motor blew and they had looked at his BUDS history report. They saw the air intake numbers were through the roof and immediately killed all his extended warranty even after we offered to send them pics of the sled in the shop. Just a heads up guys for your information.

Thanks for the heads up, honestly not too worried about warranty, just want the fkn toilet to run. Had two out of two trips ruined this year so not a very good average hahaha. Might have to buy a spare sled if his keeps up lol
 

Big A

Active VIP Member
Joined
Oct 27, 2008
Messages
327
Reaction score
1,037
Location
Rocky Mtn House
i feel like theres gonna be a lot of guys switching to axys or cat with all these issues i keep seeing on this things.

They’ve all been considered at this point, even thought about the Salamnder, Or just back to the good old XM lol. Have to wait and see if it’s a sled issue his time or somethin with the kit, maybe I shouldn’t have fkd with it Hahaha. Ran great last year lol
 

fredw

Active VIP Member
Joined
Jan 15, 2010
Messages
3,317
Reaction score
3,586
Location
medicine hat
Lost a 850motor on my 18 last month, no apparent reason.. Just died.. Thank god no turbo was installed yet as I was planning to do install a week later.. And it would of been blamed for its destruction sure as sh1t..

starting to to have second thoughts on turbo in this motor.. As I'm not to sure it's as strong as brp as lead us to beleve, dealer says a a ring stuck a port, no reason why.. Will it happen again, sure could

thank got for the trusty 800 etecs..
 

Attachments

  • image.jpg
    image.jpg
    238 KB · Views: 575

mountainsledmania

Active VIP Member
Joined
Dec 28, 2009
Messages
1,187
Reaction score
1,231
Location
sherwoodpark
i love my boosted xm. and i love xms in general. But when i do buy another machine im thinking it could be a boosted axys. Im thinking another 850 will be off the table for me.
 

NeilV

Active VIP Member
Joined
Jan 4, 2009
Messages
203
Reaction score
470
Location
Busby Alberta
My buddies 18 cat dropped and skirt and put a hole in the cases after 82km. Can happen to all of them. Can't say all doos are crap after reading a few stories on the internet. 2000km on my 850 now and it has been flawless.
 

mountainsledmania

Active VIP Member
Joined
Dec 28, 2009
Messages
1,187
Reaction score
1,231
Location
sherwoodpark
Im not saying they are crap at all, Im just saying i own 2 xms one of witch is boosted, never had an issue with all the abuse, and i have an 850 silber turbo... and ive put some beating on it as well... i haven't had any issues as of yet. But it seems the ratio of good ones to lemons is higher then previous years. I always thought of skidoo as pretty much a bullet proof machine. seems like since 17 they have had more issues then i think are acceptable, and im not a fan of how the they are getting stingy on warranty. Thats just my opinion. The whole belt issue... that was a complete mess.
 

Big A

Active VIP Member
Joined
Oct 27, 2008
Messages
327
Reaction score
1,037
Location
Rocky Mtn House
So to keep this up to date, As per the most common theme from others, I decided to pull the plugs, wow, not a sweet job for a guy with giant mits, see attached for pto side, covered in some nasty goopy two stroke goodness, was not expecting to be that bad, then I pulled mag side, not too bad but cleaned them both up to just about good as new, put me back in and same thing, won’t start without having to nurse the flipper like a poorly jetted Indy fkn storm, still not throwing any codes. Maybe tomorrow I’ll actually try a new set of plugs and see if that helps. I am really starting to wonder after seeing plugs that gross if this isn’t an injector or reed issue. Thanks to all those with valid input. Kanedouche, suck it Hahaha
2929d02bf6ed97530168bf73e1bda6bd.jpg
 
Top Bottom