2013 skidoo xm problem

[MK4TDI]

At that point it is yes. That sled had to be around 6000 rpm to throw that code, then it would pop and fart and stumble and bog until you held it to the bar for 4-5 seconds. Then away it would go, but the code wouldn't clear. More or less stating you can have rave codes in the low end too. The sensor monitors the Open, Mid and Closed positions, and will throw a code if they aren't reached.

 

[dgjordan]

well took it to mms today.

they scanned It did a few updates and said it was fixed...took it for a ride after..still there..ill be calling them tomorrow..this is becoming a pain.

 

[slededjr]

Rave valve solenoid wire. Check them thoroughly. Check solenoid to. Have even seen the wire basically corroded off of the pin inside the connector.

 

[MK4TDI]

well took it to mms today.

they scanned It did a few updates and said it was fixed...took it for a ride after..still there..ill be calling them tomorrow..this is becoming a pain.

Hahaha. They told my friend in that video the same thing 6 or 7 times. Then he trade it for a 15. They changed every rave component, and TPS and still couldn't get it figured.

 

[dgjordan]

its not the raves.its a p0326 which is a knock sensor code..it only comes on if you hold it at 6200 for a good run.then flickers then shuts off below 6200,come to a stop go wind it out and it only comes on past 6200.the motor is def not knocking as martin said the same thing.so im thinking maybe a bad knock sensor.

 

[Vance Matheson]

well took it to mms today.

they scanned It did a few updates and said it was fixed...took it for a ride after..still there..ill be calling them tomorrow..this is becoming a pain.

Try riverside i dont think mms has any good mechanics...

VanceM

 

[snopro]

If you can get Gerry Holte from Martins to look in on it. He is the service manager at Martins South I believe. I would put him up against any tech in Western Canada right now.