Search results

Another trick with the mothers mag and aluminum polish is to put some flour on the rag that you will be buffing off the grey/black paste. I don't know why it works but it does. It comes out shinier with the flour than without.

Yeah thats definatly in nice shape. Might be some helpful info here wedge front suspenssion - SnoWest Snowmobile Forum

The info that you need for the suspension swap should be here JBShocks snowmobile shock rebuilding Why not just switch everything to the xlt chassis

I have been researching this subject also and Yes an extra 10 will fit into the wedge chassis. I have read that the extra 10 is better than the extra 12 and they are more readily available. The extra 10 front suspension is suposed to bolt right up also. I have the measurements to instal the...

Sure sounds like a weak battery or a bad connection. Test your battery or even try boosting it and clean all the battey connections right to the starter.

I am not 100% sure about the front end but I don't think you will have to change the steering. Are you going to put the rear suspenssion in also. If you are, use the xtra 10. I have had no experience with the xtra 12 , but from reading all the forums the xtra 10 is better. I have a diagram for...

I have been around sleds for a long time now and just found something out, I think. I really hope this doen't make me look stupid but....... I was hooking up a visor plug on my sons indy 400, (non electric start) so I was looking for a 12 volt supply. In the manual it shows an accesory wire, the...

good point

Try tracksusa.com they have extention kits for rails and tunnels for just about any sled Tracks USA, Largest Dealer of Snowmobile Tracks and Parts

I have heard of guys using pam cooking spray. Never did it myself though.

My 03 rx1 and my buddys 07 venture do the same thing. Not really sure what the problem is but it hasn't caused me any greif so far other than turning over for a bit longer. If anything I would say to clean the carbs. and check the fuel line for leaks. Sounds like maybe the gas is draining back...

Well I had a few issues but I figured it out. Here is the finished product

I also have a thread going on this in the aftermarket suspension section. Sorry for double posting but I am desperate for help on this issue. Has anyone installed a zx2 skid into a 03 rx1 or any rx1 for that matter. They are all the same. I am in the process of doing it now and I have a serious...

Has anyone installed a zx2 skid into a 03 rx1 or any rx1 for that matter. They are all the same. I am in the process of doing it now and I have a serious issue. It's an 03 rx1, 136" x 1.75" lug track with 7.125" drivers, 2.58 pitch. All measured out with the correct measurements the rear...

I just found this site and joined, It seems from the reading that I have done that it is mostly a Canadian site. I like that. I am a member of some other great forums but they are mostly geared to the US. They are all great site though, but it's nice to see more info on the areas that I live and...

I would check all of the above. 1crazieyamaha said exactly what I was thinking. The temp light on startup of a cold engine means exactly that, cold engine, and you shouldn't move the sled until the light goes out and the engine is warm. But if you have had the sled for awhile you should already...