yamaha codes

[jusipi]

rs vector 120 has a code 30, can you tell me how to turn the main relay on or do i need a new part for this? thanks

 

[jusipi]

if the code show,s 30 how do i turn the main relay on ,

 

[Bob-yam]

i have same problem. is thre a way to clear to code

 

[Bob-yam]

i have same problem. is there a way to reset it?

 

[mtnlite]

Just got back from McBride Hubby's sled fx nytro mtx is showing code 33 which should be a coil, changed coils and still getting same code. Does anyone have any ideas?? (also sat in dry garage (spindrift thanx glen) for 3 days thinking it may be water in somewhere).

 

[mtnlite]

Just got back from McBride Hubby's sled fx nytro mtx is showing code 33 which should be a coil, changed coils and still getting same code. Does anyone have any ideas?? (also sat in dry garage (spindrift thanx glen) for 3 days thinking it may be water in somewhere).

Found it...was a broken wire coming into the main housing and was for coil #1

 

[sledhead69]

Did you ever find out what the issue was.........had this happen this past weekend

 

[sledhead69]

I have a code 20 and it is blowing a fuse by the starter solenoid......any one help me? I have to figure out what this fuse is for but when it blows the fuel pump stops! I can cycle the fuel pump for 5 mins buy turning the key on and off for 5 mins.....fuse stays good.....if I start sled it will run for 20 seconds then blow the fuse. WTF!

code 20 is: 20 Intake air pressure
Atmospheric pressure Defective values are detected due to the internal malfunction Fixes the intake air pressure and atmospheric pressure to 85.0 kPa. Able Able

every sevice manual that I have found is different than what I need....I need to find out what the two fuses on the solenoid are for.....the manual shows one main (30 amp) and that is it.....I have that one plus 2 10 amp fuses on each side......one of these is the one that keeps blowing!

Mine is doing this...............did you ever figure it out????

 

[overkill131313]

what fuel box do you have? I was told its the pure logic fuel box since I changed the two pressure sensors and it still has a code 20!

Mine is doing this...............did you ever figure it out????