Xp running issues

Backyard xp

New member
Joined
Mar 10, 2013
Messages
4
Reaction score
0
Location
Edmonton
I have an 08 summit was riding yesterday starting vibrating and running crappy brought it home now it shakes bad at idle runs rough till about 5000 rpm anybody have any ideas it's backfires till you get it revved up
 
Last edited:

Lowlife82

Active VIP Member
Joined
Jan 22, 2012
Messages
5,643
Reaction score
5,572
Location
.
Like teeroy said start at the primary and probably start working your way in. I'd be checking bearings myself.
 

Ape

Active member
Joined
Nov 6, 2011
Messages
46
Reaction score
36
Location
Prince George B.C.
Mine just I'd the same thing. Check your compression it will be it a piston. Pulled the head on mine and there was a little chip in the piston but it is not all the way missing. It idles real rough and runs fine at half to wide open is what mine did. Going to pick up a new short block tomorrow and put it in as the crank will need work in awhile anyway. I will bet this the samething that happened to yours. Mine had 135 compression on one side and 30 on the other. Good luck and I hope I am wrong.
 

oler1234

Active VIP Member
Joined
Nov 20, 2008
Messages
3,651
Reaction score
6,207
Location
Calgary, AB & Golden, BC
I have an 08 summit was riding yesterday starting vibrating and running crappy brought it home now it shakes bad at idle runs rough till about 5000 rpm anybody have any ideas it's backfires till you get it revved up[/QUOTE]

i would say a clutch but if it is backfiring you have other problems, check compression. every change the spark plugs? bad fuel mayby, crank bearing, etc.
 

bayman

Active VIP Member
Joined
Nov 11, 2008
Messages
913
Reaction score
725
Location
Calgary
When my crank let go, it was the mag side bearing. Almost dead on the same miles. I got a $20 that says it's the crank.
 

POWDERSLUT

Active VIP Member
Joined
Feb 15, 2008
Messages
2,152
Reaction score
1,308
Location
Da Loops
have u ever done a rebuild of ur primary??i bet its a worn bushing and trashed rollers n ramps..
 

Backyard xp

New member
Joined
Mar 10, 2013
Messages
4
Reaction score
0
Location
Edmonton
Crank is twisted one piston is only half a piston above the other where's the best deal on an engine
 

LinkTank

Active VIP Member
Joined
Nov 18, 2008
Messages
219
Reaction score
328
Location
Sherwood Park
I had a feeling that was it. My 09 had the exact same problem. But it didn't have the backfiring. I got everything replaced by Martin. Once again they did a great job of going to bat for me with BRP and getting it covered under warrenty. Not gonna happen with yours obviously. But the have a great service department. Outside of that I'd look into finding a written off sled. Try and find an etec if possible.


Sent from my iPhone using Tapatalk
 

POWDERSLUT

Active VIP Member
Joined
Feb 15, 2008
Messages
2,152
Reaction score
1,308
Location
Da Loops
Crank is twisted one piston is only half a piston above the other where's the best deal on an engine

really and it still idled.. have a buddy that spun his crank on his 07 but it wouldnt idle and sounded like it was only runnin on one side
 

imdoo'n

Active VIP Member
Joined
Jan 15, 2008
Messages
58,430
Reaction score
51,887
Location
alberta from the back porch
Crank is twisted one piston is only half a piston above the other where's the best deal on an engine

sorry to hear, i was hoping i was wrong, mine did the exact same friggin thing, i lucked out on a wrecked sled. short block is the way to go, forget rebuilding it, let someone else have the fun, fyi there was nothing salvageable on the clutch side of my motor.
 

NotoriousNRB

Active VIP Member
Joined
Sep 21, 2010
Messages
164
Reaction score
17
Location
Calgary SW
really and it still idled.. have a buddy that spun his crank on his 07 but it wouldnt idle and sounded like it was only runnin on one side

had this same thing on mine. finally finished rebuilding it. should have just got a new motor
 
Top Bottom