Track Ratcheting

[gedakbx]

There is a Polaris sitting beside it right now I will see how the driver look on each of them

 

[struglin]

Update , rode last week in some drier snow and no issues to report, seems it was the wet heavy snow. After reading this thread I definitely believe if it was after market drivers it likely wouldn’t of happened at all.


Sent from my iPhone using Tapatalk

 

[oler1234]

Track ratchets what else is new…

Typically does this in heavier snow or revy stuff.

Tigher track to 5/8” sag with 10lbs hanging off the bottom. You will reduce this problem by 90%

What really inflates the problem is a center shock setup really softly, typically over 70km track speeds it will start to collapse the shock and loosens the track even more

175 users this is a really problem with track stretch

 

[snoflake]

Its not an uncommon thing. New sled, new track. Track stretches, track skips tighten track. Carry on.

 

[tmo1620]

Its not an uncommon thing. New sled, new track. Track stretches, track skips tighten track. Carry on.

Ya seems like this is rocket science to some people? lol….. happens with every long track mountain sled. After the first couple tighten ups from new it should be good


Sent from my iPhone using Tapatalk

 

[greenthumb]

Any sort of feedback/consensus on the best solution for this? Having to run my track excessively tight these days.
Drivers? Powder freak vs. Avid? Fully clipping the track? Seems like a lot of work.
There a part number for the '25 stock drivers, but sounds like they won't be available for quite some time.

 

[gedakbx]

Powder freaks or avid both will work

 

[oler1234]

Any sort of feedback/consensus on the best solution for this? Having to run my track excessively tight these days.
Drivers? Powder freak vs. Avid? Fully clipping the track? Seems like a lot of work.
There a part number for the '25 stock drivers, but sounds like they won't be available for quite some time.

Avid drivers or something similar.

The problem is the stock drivers on the extroverts are built to short. So when track speed goes up, it ballon’s. That said it sometimes pulls up enough off the extrovert lugs thst basically you have reduced contact by 30-50%.

Avid drivers are taller in the extrovert and basically neglect this problem.

Past that you can go up 1 tooth size, but then the driver shaft hands below the bellypan/skid plate. Not ideal but will work.

 

[greenthumb]

So as a follow up on this. Just got my sled back from the dealer. BRP replaced the drivers and the track under warranty! They are the new 2025 version.
Complaint was excessive ratcheting and excessive tension required.
Although it was legitimately damaged from what appeared to be driver related problems, I wasn't holding my breath on the track getting covered, but surprisingly, they did.

 

[Turts]

Wow, your Dealer really stepped up for you. You should name them.

 

[tmo1620]

My buddy I think is gonna get the same treatment with his, he had the same issue


Sent from my iPhone using Tapatalk

 

[greenthumb]

Wow, your Dealer really stepped up for you. You should name them.

Courtenay.

 

[drew562]

Best

Courtenay.

Stew !!

Martins would’ve wanted snow samples to see what kind of material you were riding in lol