captain extreme
Active VIP Member
So I have been getting asked a lot about some of the things I have done with my GEN 4 for addition storage, for goggles, tool kit and survival gear. Did these things to get weight off my bag, and also don't need to purchase BRP's bulky looking bag/accessories. I did 3 main things.
1. Added Storage to the compartment where the Battery would sit. Used this space for emergency supplies and things I would not utilize on a daily basis. First aid kit, Survival Kit, Tow rope/strap, starter clutch rope, and a few other smalls.
2. I always hated carrying tool on my back, why did ski-doo go away with the handy plastic under hood compartments on the ZX's and REV's...? So I decided to kick it back old school and base my tool holder off of that design, using 3" PVC and Cap. Used the KLIM tool bag to fit into it with a ski strap to keep it from bouncing out.
3. Goggle storage and dryer, Loved it on my XM's over the clutch side, miss it on the GEN 4. So picked up this handy mesh bag and mounted it on the MAG side and seams to work decent, with 3 days on the sled no issues so far! Just a couple of holes and a zip tie and done!
Mike
1. Added Storage to the compartment where the Battery would sit. Used this space for emergency supplies and things I would not utilize on a daily basis. First aid kit, Survival Kit, Tow rope/strap, starter clutch rope, and a few other smalls.
2. I always hated carrying tool on my back, why did ski-doo go away with the handy plastic under hood compartments on the ZX's and REV's...? So I decided to kick it back old school and base my tool holder off of that design, using 3" PVC and Cap. Used the KLIM tool bag to fit into it with a ski strap to keep it from bouncing out.
3. Goggle storage and dryer, Loved it on my XM's over the clutch side, miss it on the GEN 4. So picked up this handy mesh bag and mounted it on the MAG side and seams to work decent, with 3 days on the sled no issues so far! Just a couple of holes and a zip tie and done!
Mike