Rev limit warning light

[altaredneck]

Just changed the can on my sons 2013 800 summit and when we went out he got the rev limit warning a couple times when climbing and it doesn’t sound right at high rpms when climbing. Almost like it’s boggy. Would changing the can cause this or maybe bad spark plugs. Put on a mbrp trail can. Just looking for advice to check before Xmas break. Thanks for any info

 

[kimrick]

Just changed the can on my sons 2013 800 summit and when we went out he got the rev limit warning a couple times when climbing and it doesn’t sound right at high rpms when climbing. Almost like it’s boggy. Would changing the can cause this or maybe bad spark plugs. Put on a mbrp trail can. Just looking for advice to check before Xmas break. Thanks for any info

Absolutely changing the can will or could change peramiters..
Change back to original and run in the same conditions.. Bet it is fine....
Click down some....
Noise over performance????
Weight savings?????

Have fun and ride it like a pony was stolen from the stables.

 

[AreWeThereYet]

Had a 2015 xm with MBRP trail can, ran clicker 3 from 2500 to 8000ft no issues

 

[NoBrakes!]

Get the latest flash into the 2013, it will help. The mbrp was known to cause issues on early Xms (2013), you could try the spacer that pulls the exhaust sensor out an extra 1” Too

I’d go back to stock and check. Stock life’s happy

 

[AreWeThereYet]

Get the latest flash into the 2013, it will help. The mbrp was known to cause issues on early Xms (2013), you could try the spacer that pulls the exhaust sensor out an extra 1” Too

I’d go back to stock and check. Stock life’s happy

Yup, when in doubt put it back to oem

 

[kimrick]

Get the latest flash into the 2013, it will help. The mbrp was known to cause issues on early Xms (2013), you could try the spacer that pulls the exhaust sensor out an extra 1” Too

I’d go back to stock and check. Stock life’s happy

Wow, Getting really old.
Yes, forgot about adding washers....SPACERS on the sensors....

I would just run it stock myself...I did.

If the THE THING can doesnt work on my sleds, I run it stock.

 

[tex78]

Wow, Getting really old.
Yes, forgot about adding washers....SPACERS on the sensors....

I would just run it stock myself...I did.

If the THE THING can doesnt work on my sleds, I run it stock.

Have had two xm's with thing cans, still have one

First can went through both sleds and has 15000 plus km and counting, with no codes, issues ect

Top notch can

 

[team dirt]

Check the negative wire on the oil pump being broken. I have heard that can cause on over rev limit and also a warm up code to flash on periodically.

 

[altaredneck]

I ended up changing the spark plugs and took it for a rip with the little snow we have here. It seems better the old plug looked burnt so here’s hoping that’s all it was. Will test again if we get the snow the forcast says. Thanks for the input guys

 

[NoBrakes!]

Throw some heat tape on the recoil if he’s keeping the can.

get him a muffpot for xmas. The names hilarious xmas morning and warm food is the only reason I would run a can again.....