Pulling 700 and splitting the case

[vans]

Wondering if a flywheel puller is needed to actually take off the flywheel or if the is a trick to it if not where did u buy the puller from? Oh it's a 06 cf 700 with a seized pto side piston

 

[cnelson6]

Steering wheel puller with proper bolts

 

[slomo]

I you need any parts I sent you a pm

 

[catinthehat]

We use a three bolt puller from Princess Auto, remember you need metric bolts though.

 

[vans]

Any idea what size the bolts are?

 

[calgarysledguy]

Cant remember the size.... But don't put the bolts in to far or you will wreck the stator

 

[catinthehat]

Any idea what size the bolts are?

The bolts are 8mm thread, you need them about 2 inches long though. As said before don't put them in too far, don't use an impact either , and be careful don't drop the flywheel when it pops off. Past experience has shown that will break the magnets. lol

 

[CatMan16]

Leave the nut on when your pulling the fly wheel off just have it loose. Then you won't damage anything.

 

[moyiesledhead]

Resist the temptation to wack the puller with a hammer as well. That's also been known to break the magnets. I hate learning these things the hard way!

 

[LB_]

Cant remember the size.... But don't put the bolts in to far or you will wreck the stator

Ha! Been there, done that....on my last doo.