crooklyn
Active VIP Member
I'm going to premix and need some advice on the setup. I have a 2001 Summit 800 motor. I picked up the Block off plate, gasket and oil line, as per this picture:
On the top part of the block it has a small oil tank that is piped in, but from what i have read some people just use an oil line that is plugged off instead of using a tank. Is this ok to do so? (cheaper and easier if possible)
Also other then draining my oil and gas before doing this do i have to prime the oil line on the bottom or some how make sure that there is no air bubbles in the hose? (#26 on the picture at the bottom)
On the top part of the block it has a small oil tank that is piped in, but from what i have read some people just use an oil line that is plugged off instead of using a tank. Is this ok to do so? (cheaper and easier if possible)
Also other then draining my oil and gas before doing this do i have to prime the oil line on the bottom or some how make sure that there is no air bubbles in the hose? (#26 on the picture at the bottom)