Octane Requirement for a Etec

oler1234

Active VIP Member
Joined
Nov 20, 2008
Messages
3,652
Reaction score
6,207
Location
Calgary, AB & Golden, BC
I know what it says on the gas cap but... has anyone tried 89 for mountain riding?

I know with mine it develops a crazy stumble and studder at idle when i got 94. With 91 it is somewhat gone around the 5500 elevation mark. Just wondering if anyone is running 89 without any problems.
 

moyiesledhead

Active VIP Member
Joined
Oct 12, 2008
Messages
5,455
Reaction score
10,890
Location
Moyie B.C.
I know what it says on the gas cap but... has anyone tried 89 for mountain riding?

I know with mine it develops a crazy stumble and studder at idle when i got 94. With 91 it is somewhat gone around the 5500 elevation mark. Just wondering if anyone is running 89 without any problems.

Why would you run 94 in a sled that only requires 91? :confused:
 

Hillclimber

Active VIP Member
Joined
Sep 28, 2007
Messages
1,442
Reaction score
271
Location
Penticton B.C
When I'm up at work we don't have 91 we have 89 it runs just fine. But a little sluggish needs the 91 for the full power.

Sent from my SGH-I747M using Tapatalk 2
 

drew562

Active VIP Member
Joined
Mar 13, 2008
Messages
5,473
Reaction score
21,441
Location
edmonton
I have been on long rides and filled at gas stations that only have regular 87 The etec has a great knock sensor and will recognize bad fuel and tunes for it. It's not something I would do all the time and you will notice a power loss but the sled will run fine on 87 in a pinch
 

neilsleder

Active VIP Member
Joined
Oct 18, 2009
Messages
9,618
Reaction score
17,005
Location
Leduc Alberta
The 94 is petro can gas? If it has a stumble it might cause that 94 has ethanol in it to get the extra three octane points.
 

hpjunkie

Active member
Joined
May 4, 2009
Messages
83
Reaction score
79
Location
High Prairie,AB.
Ran Shell 91 for two tanks, then 87 For two tanks @ 2000' elevation. Can't feel/see a difference. Sled pulls strong with either octane. Compression is less here @ 2000', than at sea level. Does the ignition timing vary based on atmospheric pressure?
 

greenthumb

Active VIP Member
Joined
Mar 16, 2013
Messages
734
Reaction score
2,716
Location
Shuswap
Why would you run 94 in a sled that only requires 91? :confused:

FYI:
Chevron 94 does not contain ethanol. Chevron 87/89/91 may contain up to 10%. The pump says so. Also, the 94 hose is separate from the other grades, so you don't get a few litres of 87 from the previous fill up.
Shell 91 also does not contain ethanol. It is 'nitrogen enriched'. I do not know the pros/cons of this.
Esso says up to 10% for all grades. The same for Mohawk. Petro-can's wording is cryptic, but my understanding is that all grades may contain up to 10%.
From what I have read, it is strongly recommended to stay away from ethanol in etecs. I believe it.
I have also read/heard/experienced enough to believe Techron (chevron) is a significantly better and more effective additive than other brands.
I have been consistently using chevron 94 is several sleds, (including a turbo 4 stroke) with good results.
I have tried a few tanks of Shell 91, and feel (seat of the pants) that my '14 XM runs better, more consistent, and has more power on Chevron 94 over Shell 91. Just my opinion though.

Octane requirements go down as altitude increases. Using a higher octane in an engine that doesn't require it is of no benefit. AFAIK, etec octane requirements are the same for all models. Assuming they all use the same map, theoretically 89 would work at a higher altitude just as effectively as 91 at sea level. What altitude, I cannot say. One chart I have read claims 89 @ 4000' is the same as 91 @ sea level, but I would not take this as fact.
 
Last edited:

Director

Active VIP Member
Joined
Oct 11, 2012
Messages
400
Reaction score
497
Location
RockyView
Does the sled compensate for atmospheric pressure and fuel quality by measuring air density in and exhaust temp out? Should be able take a read from both sides and adjust air/fuel mixture as required..
 

Polar_RMK

Active VIP Member
Joined
May 27, 2013
Messages
291
Reaction score
138
Location
Ontario
I don't think so, seems too complicated to me.
I would say air density doesn't change much with atmospheric pressure. It's a function of temp mainly.
Moisture will have more effect on air density then atmospheric pressure.
I am talking about atmospheric pressure on constant altitude.
 
Top Bottom