MCBPerformance, Plug-N-Go

[zeeberg7]

Hey guys, Just saw this online and thought I would throw it on here to see if anyone has seen or used one of these.

What do you guys think? I can see this helping performance, but would there possibly be something Negative about this product?

Does anyone have one of these? or have any experience with them?

Any info would be greatly appreciated, I have attached a link to the write up below.

Plug N Go for Ski Doo 2008-Current XP

thanks!

Slednecks 15 is out today, time to get the sleds ready!! LOL

 

[tex78]

Huh. Dunno. Might work awsome

sent from my htc

 

[takethebounce]

Pretty expensive for a 10 cent resistor.

There were guys running resistors a few years ago. It just fool's the ecm.

I think it ended up being worse as when the sled did go into limp mode the motor was so over heated it just about burst.

Sent from my HTC-Z710a using Tapatalk 2

 

[maxwell]

rkt or shr makes this aswell i beleive.....

 

[MtnMaster]

DooDoctor has one as well, but i ws nervous of the fact that once you do see the light or limp mode, it may be too late. Some one out there must be running one...??

 

[DaveB]

Home Page See bottom o0f this page.

Ran one for 2 seasons on my 09...worked great.

 

[zeeberg7]

On your link it says that the Temp alarm will not work if this is plugged in. So, if I were to get the temp module for my 2008 Everest guage cluster, would that be useless? would I need a different guage setup? or can I still see my temp, just no alarm and flashing light?

Thanks for the info guys, keep it coming!

 

[DaveB]

That's the "race plug and go"...scroll down a hair more. The alarm on my 09 still worked (and the ECM limited the machine)...it was just at a temp 20* warmer than before (like 220 instead of 200 F)....which is still low enough that engine damage shouldn't be an issue.

 

[HPCrazy]

I would recomend the engine tech thermostat. works great.