Liftin the front end on an 01 summit?

boondockin

Active VIP Member
Joined
Feb 26, 2008
Messages
182
Reaction score
0
Location
deer lodge montana
Does anybody know how i can get the front end up higher on an 01 doo? longer shocks? different shock brackets? i have a 144 skid extended to a 151 via rail extensions, i was going to drop the 151 extension and relocate the skid if i can figure a way to get the front up
 

timbo

Active VIP Member
Joined
Dec 18, 2006
Messages
1,088
Reaction score
386
Location
edmonton
move skid back 3.5" down 1" you'll need 4" drop brackets on rear susp mounts.
also make up reinforcing plates for front mount,inside and out.
let out your limiter straps,will let frontend lift out of snow.
i did this to my 01 800 summit works good,skis about 8-10" off snow on a good pull.
 

boondockin

Active VIP Member
Joined
Feb 26, 2008
Messages
182
Reaction score
0
Location
deer lodge montana
move skid back 3.5" down 1" you'll need 4" drop brackets on rear susp mounts.
also make up reinforcing plates for front mount,inside and out.
let out your limiter straps,will let frontend lift out of snow.
i did this to my 01 800 summit works good,skis about 8-10" off snow on a good pull.

Thanks timbo, I'm Thinkin about leaving the 151 extensions on it and putting a 159 on it? would this work or would i need different extensions
 

POWDERSLUT

Active VIP Member
Joined
Feb 15, 2008
Messages
2,152
Reaction score
1,308
Location
Da Loops
The stock tie rods and shocks on a 02 03 summit are 1" 1 1/2" longer giving you a 1 - 2 " rise in the front end of your sled,you just need the 2 shocks,and 4 tie rods fairly easy and then cut off your sway bar that runs through the bottom of the bulkhead.Way more travel with easier sidehillin ,helps suck up the BIG whoops,a little looser on hard packed trails though
 

RK Tek

Active member
Joined
Mar 18, 2008
Messages
132
Reaction score
171
Location
Idaho
Website
www.2strokeheads.com
Very simple.. Especially if you have an aftermarket front end..

1) Switch the right and left upper shock mount bracket. You will also need to invert them for the switch.. This gives you tons of clearance.

Kelsey
 
Top Bottom