Chinese diesel heaters for enclosed sled trailer

catmando

Super Moderator
Moderator
Joined
Nov 7, 2006
Messages
9,048
Reaction score
6,783
Location
Edmonton
After using mine a few times it’s pretty slick. Was about -5 out and I set mine on high and left it on for about two hours, was too hot in my trailer. Mounted my battery tender and a 12 volt fan( same as the ones in a school bus) Moves the air around hood a d dries the floor out pretty quick.
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,086
Reaction score
56,162
Location
Leduc
After using mine a few times it’s pretty slick. Was about -5 out and I set mine on high and left it on for about two hours, was too hot in my trailer. Mounted my battery tender and a 12 volt fan( same as the ones in a school bus) Moves the air around hood a d dries the floor out pretty quick.


What kind of fan? Where did you mount it?
 

catmando

Super Moderator
Moderator
Joined
Nov 7, 2006
Messages
9,048
Reaction score
6,783
Location
Edmonton
This is the update, still need too take care of wiring but fan and battery charger are installed
1e0020789b2c4cf0b9be0a7c8ed90e43.jpg
 

Bernoff

Active VIP Member
Joined
Mar 11, 2010
Messages
1,386
Reaction score
1,338
Location
Edmonton
They have Pex line on underside of trailer and use a Wabasco heaters to heat the coolant.
Never been around floor heat so wondering if you lose heated air by opening rear door, then close it, does it recover quickly enough to change clothes inside?
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,086
Reaction score
56,162
Location
Leduc
I replaced my Rv battery today. Added a 6 amp battery minder and a fan.

After the battery died while the heater was running it did not want to start.

Today I took it apart. Cleaned out all the carbon and crap from poor burning from trying to restart it with a crappy battery
It took 45 minutes to remove, clean ,reinstall and turn on. Very easy.

So important thing to remember is a a good fully charged deep cycle battery. With 10 amp start up. 1 amp to run and 10 amp shut down.

Reason I added a 6 amp battery minder is running a fan , charging phone and heater running. When Inrun the generator it will charge battery while still running everything.
 

fredw

Active VIP Member
Joined
Jan 15, 2010
Messages
3,317
Reaction score
3,586
Location
medicine hat
Just purchased a cube with a espar diesel heater.. it was not used in 7 years and did not need much to get working again other than a good battery voltage and fuel..

It runs to the truck cooling and heating system as well to keep truck warm as well cube, he has a fan heat exchanger inside cube to extract heat for cube..

Only ran it a few hrs so far with warmer weather but wanted to know if only one heater is needed or should I set up a second to warm a 14x8 cube on colder days.. it is fully insulated thou..

It is tied in to a 5 gallon boat fuel tank but plan to plum it to truck fuel tank later if it has a lift pump, pretty impressive to work after that many years sitting

ef662f7fdcbd31a9209b04c658c3d2e0.jpg

4ac6378e92b94461ff48189109a2ea8b.jpg
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,086
Reaction score
56,162
Location
Leduc
Learned why my heater would flood at 3 or 4 hours

The hertz pump pulse and fan speed came set for sea level

I lowed pulse hertz and increased fan speed.

Ran today for 7 hours while I worked on the door.

Zero issues
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,086
Reaction score
56,162
Location
Leduc
These are instructions to my panel
09cdfc3bb5b87710a7d4caafe74923d0.jpg
 
Top Bottom