GregW
Active member
Just curious and for those that have done it, doesn't matter which, 860, 872 or 875. All in start to finish with the necessary clutching and gearing complete, what did you spend?
Big Bore cost - CDN $$
- Thread starter GregW
- Start date
hbar218
Active VIP Member
I looked into it and it was in the $4-$5000 range installed depending on options. This was for 872 Trygstad
Last edited:
BeachSled
Active VIP Member
Here is the cost for the 875 i did.
Engine - 3500
Clutch kit - 460
Gears & chain - 380
Thermostat - 245
Labor - I had a bunch of other stuff done at the same time so my labor is not an accurate representation. But from what I remember it is about 8hr labor for the motor work.
Does that help ?
Call Brent himself for the 875 kit or seeing as your an hour away from Ralph, Call him for his port/head mod. Both will give you a "all in price" to do the complete install for you clutching and all.
Brent is gonna cost more either way just because he is down south,meaning you would have to drive it down to him or have a second party put it in.. I talked with Ralph about Brents 875 kit and he was willing to install the kit if I wanted to but I ended up going with Ralphs port job and Bakers clutching kit (which was all OEM skidoo parts) it pulls very hard now!
Brent is gonna cost more either way just because he is down south,meaning you would have to drive it down to him or have a second party put it in.. I talked with Ralph about Brents 875 kit and he was willing to install the kit if I wanted to but I ended up going with Ralphs port job and Bakers clutching kit (which was all OEM skidoo parts) it pulls very hard now!
Similar threads
