- Thread starter
- #41
skegpro
Active VIP Member
Thanks, it will be a crapshoot if DHL shows up in time or not, or if they even have it on the truck.I will see tomorrow if anything pops up on the dealer locator tomorrow for you
Thanks, it will be a crapshoot if DHL shows up in time or not, or if they even have it on the truck.I will see tomorrow if anything pops up on the dealer locator tomorrow for you
No worries, I was able to rig up some generic prefilter. Looks like these are back ordered for a while.Sorry I didn't get this posted yesterday skeg, But dealer locator says T&T in bonnyville has the right side. left side is a shop in wyoming that is all.
.....................K I need to pick your guys brain.
I wanna get rid of the goggle bag and put the early release vent in.
But I wanna ad some prefilter. So snow doesn't drop in the engine bay but heat can still escape.
I figured first I would cut a cardboard template, then cut my piece of fabric.
What glue should I use and how should I finish the edges?
Thx
//uploads.tapatalk-cdn.com/20180113/3e8e3bf0b582fcdfc04a2939ae35ed41.jpg//uploads.tapatalk-cdn.com/20180113/583cc0071af283e742900bb928c75655.jpg//uploads.tapatalk-cdn.com/20180113/6f63f6cb20b75babb0393c39ee5dbecd.jpg//uploads.tapatalk-cdn.com/20180113/fa1e58dc6ee815f20637d3ed8dbd152d.jpg
Sidewinder guys have a foam in the airbox so I don't know if they are realizing what an issues this is.Well that certainly won’t leak. Looked at mine again, and a gap opened up in the underside screen so taped it up for now. Pretty sure when I looked at previously that space wasn’t there, So thinking the plastics are getting warped. Maybe fit to the body is pushing them out or something. I set if the Sidewinder guys have the same issues?
Did you check infront of the intake duct?Mine looks perfectly fine, other than minor gaps that i taped it seems good, havent checked it since the last ride though and those were some tough miles put on in salmon
Did you check infront of the intake duct?
Big gap there.
Have you looked in through the y-pipe yet at your pistons?