2013 Boondocker Pro issue

JDmotorhead

Active VIP Member
Joined
Sep 14, 2009
Messages
164
Reaction score
84
Location
Fort Mcmurray Alberta
With new plugs the sled will idle fine then it idled down and back up, onced warmed up it will rip for about 200m and then just die like you hit the kill switch, and then won't start again, plugs are a little wet. Put new plugs in and the sled will do it all over again. Any ideas?! What is the spec for resistances on the coils? Any info or suggestions will be greatly appreciated! Needs to get back on the snow asap:beer:
 

moto5151

Active VIP Member
Joined
Jan 4, 2012
Messages
509
Reaction score
277
Location
grande prairie
Will the sled idle after you change plugs? For how long? At what point does it shut off? Cruise speed? Under boost only? Anything on the dash light up? Have you played with anything lately? Like throttle cable, etc....
 

Jordan1924

Active VIP Member
Joined
Nov 7, 2012
Messages
253
Reaction score
172
Location
Golden Bc
Is there a tether on the sled? Buddy had similar issue disconnected tether and boom gone.
 

JDmotorhead

Active VIP Member
Joined
Sep 14, 2009
Messages
164
Reaction score
84
Location
Fort Mcmurray Alberta
Sled is hard to start after it shuts down even with new plugs, got to play with the throttle while trying to start it, new voltage regulator, TPS set and good, quits under mid throttle rolling, tether is disconnected (pings tether). Thanks for the replies guys.
 

Pistonbroke

Active VIP Member
Joined
Oct 10, 2007
Messages
3,366
Reaction score
11,203
Location
Cockring, AB
Sled is hard to start after it shuts down even with new plugs, got to play with the throttle while trying to start it, new voltage regulator, TPS set and good, quits under mid throttle rolling, tether is disconnected (pings tether). Thanks for the replies guys.

Smells like maybe a stator?
 

moto5151

Active VIP Member
Joined
Jan 4, 2012
Messages
509
Reaction score
277
Location
grande prairie
Have you checked fuel filter? Fuel pressure? I had a throttle body wear out on my 12 pro turbo. Gave similar symptoms.
 

JDmotorhead

Active VIP Member
Joined
Sep 14, 2009
Messages
164
Reaction score
84
Location
Fort Mcmurray Alberta
Just finished checking coil resistance, all good, check fuel controller connections, Koso gauge connections, all good, will check the stator and fuel filter. Thanks
 

06 Dragon

Active VIP Member
Joined
Nov 17, 2006
Messages
2,185
Reaction score
3,986
Location
Red Deer County
I had a wire rub through up by the steering post on my 2012 and short out once in a while, causing a similar issue. check your wiring carefully. It haunted me for a while.
 

JDmotorhead

Active VIP Member
Joined
Sep 14, 2009
Messages
164
Reaction score
84
Location
Fort Mcmurray Alberta
Thanks for the reply, will have a closer look at the wiring, I already found some wires hanging apart and unhooked, not sure if it was just left like that from when the dealer was working on it or if they came apart on their own, was the wires going to my Koso gauge, but will have a look for worn wires, thanks
 
Top Bottom