2012 Proclimb vent kit question

mur190

Active VIP Member
Joined
Dec 17, 2008
Messages
988
Reaction score
1,226
Location
bonnyville AB
i picked up a vent kit from XXX mod rods just wondering what everone else is doin with the duct on the clutch side are ye'all leavin em out or re-installing them with the vent kit.

Thanks
 

CatRyder88

Active VIP Member
Joined
Feb 10, 2011
Messages
304
Reaction score
483
Location
Grande Prairie, Alberta, Canada
Took it off. And put a frogskin between the metal screen and the panel.


Sent from my iPhone using Tapatalk... My iPhone can climb higher than yours! :p
 

Attachments

  • ImageUploadedByTapatalk1323757301.159347.jpg
    ImageUploadedByTapatalk1323757301.159347.jpg
    57.5 KB · Views: 402
  • ImageUploadedByTapatalk1323757315.344357.jpg
    ImageUploadedByTapatalk1323757315.344357.jpg
    47.2 KB · Views: 399

Jubes

Member
Joined
Dec 18, 2008
Messages
16
Reaction score
2
Location
Rocky Mtn Hse
i picked up a vent kit from XXX mod rods just wondering what everone else is doin with the duct on the clutch side are ye'all leavin em out or re-installing them with the vent kit.Thanks
I left mine off, also didn't install the vents above and directly parallel to the primary, don't want a stick to ruin my day. Have to see if this is enough thou and if not I'll put in the other ones
 

AllanMac

New member
Joined
Aug 2, 2012
Messages
2
Reaction score
0
Location
Northern BC
Catryder88

I need a little help please. I'm kind of new to sledding, just bought a xxxmodrod vent kit. I installed the some what triangle vent over the clutch but the machined pin isn't long enough to go through the side pannel plastic and the vent. I can't seem to get the cotter pin through the machined pin like in your second photo or photo on the right. Did you have to cut the side pannel where the pin goes through?

Thanks
 

CatRyder88

Active VIP Member
Joined
Feb 10, 2011
Messages
304
Reaction score
483
Location
Grande Prairie, Alberta, Canada
Its tight but it fits. I didnt have to cut anything.
Catryder88

I need a little help please. I'm kind of new to sledding, just bought a xxxmodrod vent kit. I installed the some what triangle vent over the clutch but the machined pin isn't long enough to go through the side pannel plastic and the vent. I can't seem to get the cotter pin through the machined pin like in your second photo or photo on the right. Did you have to cut the side pannel where the pin goes through?

Thanks
 
Top Bottom