Hi every one nubie here
Here is my sad story. 2009 m6 stock just picked up the sled at auction in the spring
starts fine runs good until you hit 3/4 throttle then looses power drops revs .(sound familiar ) so take sled into to my guru . Checks servo ok puts on spare it works too. Cables adjusted ok . Ccu not working replace it. Check for obvious wires nothing found .check sensors all in spec , check coil ok , check stator ok, fuel pressure ok replaced speedo at same time as it had a moisture problem and was reading lcd. No codes on speedo after all this my mechanic says still not running right. #}?€++ t . So I take it out for a run sat same as before running down lake 3/4 throttle fine . Pin it and it looses power and fails , back to 3/4 throttle ok. Now for the best part take it out Monday heading down the lake and now for the first time it's running like it should??? Wot no miss lots of power running ok the ride was 2 hours still running good .
did absolutely nothing to it . So this makes me think I still have a wiring problem??
What else am I missing that could fix itself??? can I eliminate clutches ? I'm running the sled in northern ontario.
Thanks Jeff
Here is my sad story. 2009 m6 stock just picked up the sled at auction in the spring
starts fine runs good until you hit 3/4 throttle then looses power drops revs .(sound familiar ) so take sled into to my guru . Checks servo ok puts on spare it works too. Cables adjusted ok . Ccu not working replace it. Check for obvious wires nothing found .check sensors all in spec , check coil ok , check stator ok, fuel pressure ok replaced speedo at same time as it had a moisture problem and was reading lcd. No codes on speedo after all this my mechanic says still not running right. #}?€++ t . So I take it out for a run sat same as before running down lake 3/4 throttle fine . Pin it and it looses power and fails , back to 3/4 throttle ok. Now for the best part take it out Monday heading down the lake and now for the first time it's running like it should??? Wot no miss lots of power running ok the ride was 2 hours still running good .
did absolutely nothing to it . So this makes me think I still have a wiring problem??
What else am I missing that could fix itself??? can I eliminate clutches ? I'm running the sled in northern ontario.
Thanks Jeff
