2007 m1000 TPS???

[HippieRich]

Hey, so like the title says my tps on my m1000 is acting up. It starts and idles fine but when I give it some throttle it stalls. I disconnected the wiring harness for my bars and it runs fine minus lights heater grips and kill switch. My question is where do I go from here??? I looked and can't see if there's a short in the line, please help!!!!

 

[neilsleder]

Did you check the throttle safety switch? My bet us on that. Just snip the wires that are hooked up to that and I bet it will run. The wires you cut are in the throttle block bye the kill switch. But I would put a tether on it after cutting those wires.

 

[HippieRich]

It turns out the throttle position sensor was fine, I then followed the wires and found the short. Good as new thanks