04 800ho wont run

Thunderguy BOOSTED

Active VIP Member
Joined
Jun 20, 2008
Messages
1,423
Reaction score
337
Location
BC CANADA
Just finished rebuilding a 04 800 Ho with a RK-tec drop in kit
than installed the whole works into a 2007 XRS and yes I swaped the wiring harness and ecm over as well
so after all that. Two pulls she fired right up but when u go to give it some throttle it goes pop-pop-Pop and runs realy rich
kinda like the 4 stroks when they are cold

any help would be great.
 

Thunderguy BOOSTED

Active VIP Member
Joined
Jun 20, 2008
Messages
1,423
Reaction score
337
Location
BC CANADA
Cheers
 

Attachments

  • image.jpg
    image.jpg
    55.8 KB · Views: 200

pizalm

Active member
Joined
Jun 9, 2009
Messages
52
Reaction score
63
Location
p-dot,mb
Does it idle fine? Did you swap the coil to?


Sent from my iPad using Tapatalk
 

tex78

Active VIP Member
Joined
Feb 5, 2010
Messages
17,552
Reaction score
16,983
Location
DA Moose B.C
Do u have the temp sensor and dpm plugged in backwards

Same plugs and can be wrong as they are close

Been there after a engine swap the opposite way, a 07 800 r into a 04 chassis
 

Thunderguy BOOSTED

Active VIP Member
Joined
Jun 20, 2008
Messages
1,423
Reaction score
337
Location
BC CANADA
Update swaped out the dash now as well and got the rpm working and now I got one light flashing

also so won't rev above 3000 and it starts cutting out.
 

Attachments

  • image.jpg
    image.jpg
    44.5 KB · Views: 170

Thunderguy BOOSTED

Active VIP Member
Joined
Jun 20, 2008
Messages
1,423
Reaction score
337
Location
BC CANADA
Also that light when the sled is iddeling just flashed and a normal rate but when u rev it up to 3000 rpm then it just flashed slowly
 

Thunderguy BOOSTED

Active VIP Member
Joined
Jun 20, 2008
Messages
1,423
Reaction score
337
Location
BC CANADA
Omg this just keeps getting better. Now she's running but running out of fuel?!?? :confused::confused:
And this light is on now too
 

Attachments

  • image.jpg
    image.jpg
    41.9 KB · Views: 158

Mantis

Active member
Joined
Jan 20, 2010
Messages
66
Reaction score
151
Location
Castlegar
Just wondering which carbs you used...did you change jetting(not sure about rk tek drop in kit but if it includes his head, he usually drops a couple sizes)? Really interested in how this goes as my son is about to do the exact same swap - has good 800ho and found a 07 chassis...Keep posting as you go! Thanks
 

Thunderguy BOOSTED

Active VIP Member
Joined
Jun 20, 2008
Messages
1,423
Reaction score
337
Location
BC CANADA
They recommend 390 and jet from there. I have tryed every which way, up down and in between and still won't run right in mid range. Is it possable that iT is over oiling? My plugs are really black and smokes like a bast@rd
took it out a week or so a good and as long as u feathered it through mid range. Once she was open goes like crazy. Re-did both clutches etc. I'm down to pulling the oil injection off and just pre-mixing. Or open to any other advice. If the wrong y-pipe Is on posable that that messed everything up ??
 

Attachments

  • image.jpg
    image.jpg
    58.1 KB · Views: 123
  • image.jpg
    image.jpg
    33.4 KB · Views: 120
Last edited:
Top Bottom