Search results

They are doing better than the COILERS!:d

X 10 on the cigarette buts and trash being thrown out of vehicals. Why can people wait until they get home.:mad:

Yep just buy a new one. I bought parts to fix mine but the plastic center stub is the problem it wears out and the rewind starts to wabble and will not catch. I learned the hard way the folks at the dealer did not tell me that it was a waste of time trying to fix it. So I bought parts and a...

Went up yesterday for the day. Sorry no pics it was snowing and about -24c. Lots of land minds still. Have to be pretty careful. You have to step up into the cabin the snow is that low. Had some good boondocking around the pinebowl there was about 1 foot of fresh snow in the medows. No broken...

We use the tracking feature every day for work. I work in the oil patch on remote sites. We check in on each location with the OK feature. And if we need help like if the quad is stuck or quit, or we had a reck we activate the help. But these are in areas were our contact list of the signals are...

I am only straping it down on the front rack for backup for the winch really! And I am installing my quad chocks today it took a couple days to get them built. Thanks for you concern.:beer:

here is a cleaner pic, it is nice it has not rained for a week around here!

Where is ragged edge located?

lightning she looks good, how do like that lift? I was thinking of doing the same. I will have to post a clean pic next time.:beer:

:dhey,hey,hey just never mind my license plate they need a couple fans too!:hand:

:shrug:Mine was close to the same. 17 to 19 per 100 and now it just rolled over 44000kms and it is about 14 to 15 per 100 km. And that is with a quad and deck and a couple hundred pounds of tools, all the time. I run 35 '' rubber on it also.

:beer:thanks man that looks better, there is not a whole bunch holding that rear diff square. After some heating and beating and fixing the holes up were good to go. I will get fabing soon.:cool:

Here are a few picks of the diff and parts I found a bent bottom of the plate like you said and the bolt hole is oblong I can move the diff up and down about 3/4's of an inch when the bolt is backed off. But it was tight. I removed the diff and built up the holes so the bolt was level. The base...

Hey guys I have a 09 700 grizz the rear diff seems to be tilted to the right and the left side has been eating up cv joints. I picked up some turner axles and the size increase made it look even more tilted. The boot on the left is almost touching the upper a arm. All bolts are tight and I can...

Hey guys I have a 09 700 grizz and it has been eating up left rear cv joints. I bought a pair of turner axles and after the install the left side boot is almost rubbing the upper a arm due to the size increase. And after further inspection the diff seems to be tilted to the right about 1/4". I...

:cool:I have run the Dick Cepek fun country 2's. I am on my second set, 1st set I got 115000kms on them. Then bought a new truck and have them again. Same as above no hell on the ice but they wear good and not bad on gravel. And rotations and tire press are a big factor. 305 17" on a f-150 and...

Hey man how much for the engine if you still have it for sale?

I just purchaced a 09 grizz and i put on the two brothers pipe sounds good, but i will have to put on some miles to tel for sure.;)