Search results

should fit runs the same chaincase

I did a conversion last year 2002 summit found an mpem with key and rer for $200 used the same stator used a flywheel from a 2005 rev and pickup coils from the same rev bought a horn button at bowness auto and it worked flawlessly

check that the little hose that goes into the side of ecu didn't come off

you need a different harness on top of your clutches or it will not run if you want it to run with the existing harness you will have to reinstall battery

Darrel did you change the harness over the clutches different harness electric start and manual start

the one you plugged into mpem is probably your diagnostic plug

you can't do anything wrong at the oilpump the cable is not adjustable at the end take freeplay out of cable at throttle lever and pull inner cable out at adjuster it should be 16.5mm and if it as rebuilt engine put in half a liter of oil with a full tank of gas for the first 2 tanks then you...

59-60-61-62 that's what you should change

according to brp you are supposed to use it from +2 to -3 c when you will have a problem with freezing and humidity it is so the slides don't freeze and won't go back to idle at -20 and -30 you should not have a problem with humidity

max runout 2.4 thou

you can use them on 700 and 800 just get the spacer and the longer bolts it's a bitch to get the airbox on though

put a spi on my sled worked 2 weekends then bite the bullet bought a brp worked ever since

check the red/blue wire to the regulator that it is not grounded out

never use them brp put them on to cover their a-- if the slides should freeze for lawsuit

buy the recoil assy it will save you a lot of headache I have seen a few times where the clip went in and ruined the stator even had to change a flywheel once

stator and recoil housing is the same the crank on 09 and 10 is longer on the mag side it's a different flywheel

mpem was fried changed mpem sled running good

I am almost sure it's a 36o watt should be about 25 amps

first off without battery you need the other harness if not you are screwed already then you have to run it with the battery hooked up come and see me i have the harness and if not i have a clutch shaft with ringgear

take it to dealer when they hook up to sled the vin comes up