As per my heading i have a 2008 dodge 3500 mega cab and a travel trailer. I am wanting to get a sled deck or maybe one of those diamondback atv covers. Would like to get a sled deck but i am worried about the deck hitting the travel trailer while turning. Anyone currently have a mega cab with a sled deck and travel trailer??? Advice would be appreciated.
Which sled deck for mega cab while pulling travel trailer????
- Thread starter boxer
- Start date
ABMax24
Active VIP Member
Depends on how long the deck is, I have a 6.5' box on my duramax and with a flat deck sled trailer my 8' deck just hits the top of the wind break when near jack-knifed while reversing. My sleds sit above the level of the wind break but if it was an enclosed trailer my sleds would hit the front very easily.
If I were you I would hookup to the trailer and turn to one side or another and measure straight back from your box to see how much clearance you have and add a little for extra insurance. It would also depend upon how long of a deck you are planning on getting, obviously a 7' would clear better than an 8'
If I were you I would hookup to the trailer and turn to one side or another and measure straight back from your box to see how much clearance you have and add a little for extra insurance. It would also depend upon how long of a deck you are planning on getting, obviously a 7' would clear better than an 8'
- Thread starter
- #3
For example Marlon decks come in a 85.5" deck thats made for a 5.5 to 6 ft box. would barely hang over but the big drawback is it comes with the short ramps. they also have a 92" deck made for 6.5 " box which would hang past quite a bit. my box measures from the front bulkhead where the deck would push up to to the end of the tailgate 78". I only haul quads so dont need a super long deck. not sure what denali or x deck have for sizes but will check it out.
Bnorth
Active VIP Member
Different trailers have different reaches. I would say any deck that is only as long as the box (no beaver tail) is a safe bet. My trailer has a decent reach and would clear my old 8' deck with beavertail on my longbox. Don't think my new deck will clear.
250mark1
Active VIP Member
i have a 7 ft marathon deck on my 2012 dodge crew cab at it hangs out quite a bit probably 10" past the tailgate i need to run a long hitch extension and avoid really sharp turns to avoid hitting my trailer and i only extend my deck about 4" each side
it will depend on the front profile of your trailer if it sweeps back you may be ok
the diamond back cover would only haul one quad on a short box truck need to have the long box for 2 quads
it will depend on the front profile of your trailer if it sweeps back you may be ok
the diamond back cover would only haul one quad on a short box truck need to have the long box for 2 quads
- Staff
- #6
- Joined
- Oct 21, 2006
- Messages
- 48,082
- Reaction score
- 32,189
- Location
- Edmonton/Sherwood Park
- Website
- www.bumpertobumper.ca
Tried 4 different decks on my megacabs in the last 8 years and have punched holes in 2 different trailers... Get a hitch extension of some type
- Admin
- #7
- Joined
- Oct 20, 2006
- Messages
- 39,544
- Reaction score
- 14,743
- Location
- Edmonton Alberta, Canada
- Website
- www.sledbunnyracing.com
And both times it was funny stuff....lol.....
Sent from my phone ---- is anyone there ?????
- Staff
- #8
- Joined
- Oct 21, 2006
- Messages
- 48,082
- Reaction score
- 32,189
- Location
- Edmonton/Sherwood Park
- Website
- www.bumpertobumper.ca
No it wasn't....... 
- Staff
- #9
- Joined
- Oct 21, 2006
- Messages
- 48,082
- Reaction score
- 32,189
- Location
- Edmonton/Sherwood Park
- Website
- www.bumpertobumper.ca
Still gotta help longhair fix his sled trailer
Mike270412
Golden Boy
Or learn how to drive.
- Admin
- #11
- Joined
- Oct 20, 2006
- Messages
- 39,544
- Reaction score
- 14,743
- Location
- Edmonton Alberta, Canada
- Website
- www.sledbunnyracing.com
No it wasn't.......
Well for me it was...well later we laughed.
Sent from my phone ---- is anyone there ?????
- Admin
- #12
- Joined
- Oct 20, 2006
- Messages
- 39,544
- Reaction score
- 14,743
- Location
- Edmonton Alberta, Canada
- Website
- www.sledbunnyracing.com
Teth-Air
Active VIP Member
I have a 2010 with a 8 ft deck and pulled a v-nose sled trailer a few times with no problem If pulling the travel trailer I would only go 7 ft with an extension when not pulling the trailer. You can also put the hitch extension on if its not too big of a trailer.
- Thread starter
- #14
ABMax24
Active VIP Member
Why wouldn't you just put the quad in the box?
- Thread starter
- #17
Need to haul 2 quads once in a while.
f150truck
Active VIP Member
Hitch extension on the trailer side.
Extending truck hitch does no good when truck turns sharply with deck sides extended.
Extending truck hitch does no good when truck turns sharply with deck sides extended.
250mark1
Active VIP Member
This is my 7 ft marathon deck with my arctic fox trailer checking my turning angles the deck is not slid out and I have a large shank hitch from dsp
Sent from my iPhone using Tapatalk
250mark1
Active VIP Member
Saw a guy that built this extension that bolted to the frame of his arctic fox and used the ball mount to make the trailer tounge longer to provide more clearance
Thinking of having my buddy's welding shop make me one as well
Sent from my iPhone using Tapatalk
Similar threads
