What did you do for your ATV today?

[DieselDemon]

got the plates and insurance renewed ... legal again sweet!!!

 

[psullivan]

tearing it down to powder coat it.

 

[zeebs]

went to the post office and picked up the lift kit. Then took it to the garage, unpacked it, and showed it to it......:d

Did it grin back and say "yes give it to me?" lol

 

[zeebs]

Well yesterday I went for a ride and buried it a few times and put it in the shop to thaw it off. I was reading on another forum lastnight about the roll pins coming out/breaking off of the drive shaft knuckles so I went out to check mine and sure enough two have moved and one had broke off but must have just been holding on by a little bit and the other one I didnt check due to all the location and all the snow. So today I am fixing!!!

 

[munhoez]

Did it grin back and say "yes give it to me?" lol

I bet the machine orgasmed, shot the rad cap off, squirted coolant all over floor, on machine, in new lift kit packaging.

 

[quadboy55]

Found oil in my airbox...... $hitty....

 

[racerfromhell]

Did it grin back and say "yes give it to me?" lol

I bet the machine orgasmed, shot the rad cap off, squirted coolant all over floor, on machine, in new lift kit packaging.

LOL yes it did! :d I cant even tell you what it did when it seen me pull the jack stands out :d

 

[racerfromhell]

Well after cleaning all the mess after showing it the kit, I went ahead and installed it. The fit was perfect and went in with two of us (you need the extra set of hands to install the front brackets) and 8 beers , app 3 hours at a very leasurely rate. I gained a full two inches, no cv bind, and firmed up the ride. No more bottoming out and I set the springs at the lowest setting. A nice option is the quick front sway bar disconnect. pull a pin on the bottom mount, swing it forward and it stores up under the front bumper. As you can see by the after shot that it even looks happier......:d and yes I need a new floor in the garage

 

[quadboy55]

Looked at it, thought for a bit... Taking it to Rapid sometime next week for snorkels and going to order a 3" CATVOS lift with a 2.5" Rake.

Also I decided to sell 'em stocker tires that cometh' with the XP.

 

[rzrgade]

A few update pics of the build...

 

[rzrgade]

a few more

 

[zeebs]

looked at it and got pizzed off at the front end saging down. Going to order HD front springs tomorrow and make it look like something

 

[CrankShop910]

Plowed swow again.

 

[northern bear]

Absolutely nothing myself cause I'm at work, but my kid bagged it up and down the drive pushing snow.

 

[Brute Force Boy]

Busy weekend, got the new 30" zillas and pro armor doors mounted.

 

[rzrgade]

Very nice , what kinda ground clearence now ?

 

[Brute Force Boy]

Very nice , what kinda ground clearence now ?

Should be 13-14" now, I was just over 11" with my 26" xtr's.

 

[Open Season]

Got busy and made and installed new puck board A arm gaurds front and back.

 

[rzrgade]

Got a little more done today with intake and snorkels done....

 

[racerfromhell]

nice