Water proof wiring connections

sirkdev

Active VIP Member
Joined
Nov 2, 2008
Messages
3,273
Reaction score
5,337
Location
Stony Plain
I have a couple of wiring harness plugs underneath vehicle that are disconnected and need to remain that way that need to be sealed. Plug size is 1.5" roughly. What are the best methods? Looked at heat shrink.. paint on electric tape? Would like to never look at these again but have access to the plug if things change. Thoughts please.
 

Bnorth

Active VIP Member
Joined
Dec 18, 2010
Messages
10,778
Reaction score
20,826
Location
Salmon Arm
find matching plugs, fill wiring passages with silicone and fill connection with di-electric grease and plug them together. Or cut off the plugs altogether and heatshrink your wire ends.
 

Stompin Tom

Active VIP Member
Joined
Jun 7, 2009
Messages
3,787
Reaction score
8,138
Location
BC
IMG_0328.JPG
 

sirkdev

Active VIP Member
Joined
Nov 2, 2008
Messages
3,273
Reaction score
5,337
Location
Stony Plain
find matching plugs, fill wiring passages with silicone and fill connection with di-electric grease and plug them together. Or cut off the plugs altogether and heatshrink your wire ends.
I like that idea for sure except my issue is it plugs into a module that has gone bad and causing shorts which can cause voltage spikes back to the ecm... agh. It is for rear radar sensors on a ML 350 good ol german engineering, the module splits water gets in and causes the internal shorting.
 

Stompin Tom

Active VIP Member
Joined
Jun 7, 2009
Messages
3,787
Reaction score
8,138
Location
BC
This stuff is excellent. I use it on all electrical connections on my logging trucks. Expensive as hell, but works. No more green wire.
 

Stompin Tom

Active VIP Member
Joined
Jun 7, 2009
Messages
3,787
Reaction score
8,138
Location
BC
Thats interesting stuff have you had good experiences with it?
Very good results. With the logging trucks we are constantly in wet, salty, grimy situations, wiring is always an issue. After trying this stuff for about 2 years I am very impressed. I have had the cover of junction box's get broken in the winter, filled up with snow and crap, clean them out, put a new cover on and not have a problem. Gets a 10 out of 10 for me. Its like Franks Red Hot, I put that sh*t on everything.
 
Last edited:

ctd

Active VIP Member
Joined
Dec 14, 2016
Messages
517
Reaction score
1,496
Location
In Elevation
Hockey stick tape is the best electrical tape. Tough & protective.

If you don't mind a very good but pricey spray "deoxit"
 

Bnorth

Active VIP Member
Joined
Dec 18, 2010
Messages
10,778
Reaction score
20,826
Location
Salmon Arm
This stuff is excellent. I use it on all electrical connections on my logging trucks. Expensive as hell, but works. No more green wire.
If it's good enough for logging trucks it's good enough for me. Where do you find it?
 
Top Bottom