TRA clutch

[gofast89]

Thanks. That spacer (33) did not come in the kit but the first 2 from left in that diagram did. Those were what I was wondering about. Son has not brought his clutch over yet to look into again.

The spacer doesn’t come in the kit. Not really a wear item


Sent from my iPhone using Tapatalk

 

[Lightningmike]

Good to know. I didn't think it would wear very quickly. Thx

 

[Dynamo^Joe]

That spacer is not part of a refurbish kit. it comes in the clutch, or should come in the clutch.

 

[treeboy]

Those pins are not the ones that go through the rollers. They go in the governor cup and hold the ramps in place.

Jump on BRP's website and have a look at the parts break down.

Those pins are for mounting the arms with the bolts on each side. The ramp pins are totally different, their a hollow split pin last I checked.

 

[treeboy]

Those pins are for mounting the arms with the bolts on each side. The ramp pins are totally different, they’re a hollow split pin last I checked.

It looks like he is missing the pin weight pins for the rollers, what usually you buy separately.

 

[NoBrakes!]

There’s a guy in red deer that rebuilds TRA clutches and gives 1 year warranty. kijiji dude but I think his name is Thane. Anyone know him? I had never seen than many clutches in one garage

 

[MK4TDI]

Those pins are for mounting the arms with the bolts on each side. The ramp pins are totally different, their a hollow split pin last I checked.

You are correct. Been awhile since I've been into one. It also makes more sense with the rebuild kit as the arms are constantly moving and that pin would be a wear point. Went to go dig in the parts bins.

Gold pins in the kit go in the bottom hole on the arms.

And the bushing he has goes in this part of the sliding sheeve.. ( this is an older TRA with the spline shaft so it looks a bit different)