Timbersled basic setup tips?

[mb1]

I’m going to be installing a ‘17 Raw kit on my ‘11 Husaberg Fe570 soon and I’m wondering what to look for to know if the strut rod is the right length and if I should be adjusting anything else? I see on the yeti site they say that too much or too little ski pressure can give a “dart” feeling but I don’t even know where to start.

I’m 210# in shorts and the bike has heavy springs in it already. ( I might add Airpro after I get a couple rides in )

 

[mb1]

ok so I see that they preset the length of the strut for you. Good. So what should I watch for handling wise and what do I adjust to correct it?

I figure I could slide the forks up or down in the clamps a little bit or adjust the strut, or the skid. What are you guys doing?

Stuck at work....

 

[Big Diesel]

Find the deep stuff right away and there is no darting