The Sud's and Maintenence how too post

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,627
Reaction score
56,475
Location
Leduc
After a good sleep.

You should bring tea.
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,627
Reaction score
56,475
Location
Leduc
Well a few thinks to fix after pinning it.






Wheel cap
couple fender skirts
. Dent in door and a few
. Crushed beer's

TTeam warranty.

Supporting Martin Motorsports with parts ordered Saturday.





Sent from my iPhone using Tapatalk
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,627
Reaction score
56,475
Location
Leduc
This should buff out




Sent from my iPhone using Tapatalk
 

the_real_wild1

Active VIP Member
Joined
Oct 13, 2010
Messages
6,966
Reaction score
7,389
Location
cardiff
Ball joints, brakes, front wheel bearings, steering rack rod replacement, oil change, diff oil change, gps mount, wire in switches, stud my tires, clean rad and oil cooler, steering cable delete, and a good cleaning. Bunch of parts on the shelf and more coming this week.
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,627
Reaction score
56,475
Location
Leduc
Ball joints, brakes, front wheel bearings, steering rack rod replacement, oil change, diff oil change, gps mount, wire in switches, stud my tires, clean rad and oil cooler, steering cable delete, and a good cleaning. Bunch of parts on the shelf and more coming this week.

Best to fix at home than on the trail


Sent from my iPhone using Tapatalk
 

arff

Active VIP Member
Joined
Apr 21, 2009
Messages
142,627
Reaction score
56,475
Location
Leduc
I pull skid plate and grease. Check brake pads this week.

And go again.


Sent from my iPhone using Tapatalk
 

the_real_wild1

Active VIP Member
Joined
Oct 13, 2010
Messages
6,966
Reaction score
7,389
Location
cardiff
I pressed out the upper ball joint yesterday and went to press in the new one but it slid in by hand. Checked the service manual and sure enough I need to use green loctite to hold it in as well as the clip. Put red in before I checked the manual and it is holding but I think I am better off getting the right stuff. Spent $800 on a new steering shaft to get rid of the stupid cable setup cat has. Hopefully gets my steering to what it should be. Stock setup has way too much resistance. It is ok when riding fast but in the tight woods it needs to be better. The steering is tight enough turn wise just needs to turn easier.
 

doorfx

Active VIP Member
Joined
Jan 10, 2011
Messages
10,050
Reaction score
24,523
Location
calgary ab
I pressed out the upper ball joint yesterday and went to press in the new one but it slid in by hand. Checked the service manual and sure enough I need to use green loctite to hold it in as well as the clip. Put red in before I checked the manual and it is holding but I think I am better off getting the right stuff. Spent $800 on a new steering shaft to get rid of the stupid cable setup cat has. Hopefully gets my steering to what it should be. Stock setup has way too much resistance. It is ok when riding fast but in the tight woods it needs to be better. The steering is tight enough turn wise just needs to turn easier.

Green loctite sleeve retainer !!
 
Top Bottom