Spacers or not?

[zeebs]

Ok, i know there are tons of threads out there about this but i haven't been able to get a straight answer for my specific setup. I am looking at some itp 14" 212s with 28x9x14 and 28x11x14 zillas. I dont want to flip my tierod ends and dont want to run spacers. My quad is a 2008 800 sportsman. What offset do i need to run or can i run the factory offsets?

Sent while not working too hard

 

[neilsleder]

With 9" on the front there is a good chance they will fit. See what the stock size is and see how much clearance you have, then judge from there.

 

[zeebs]

With 9" on the front there is a good chance they will fit. See what the stock size is and see how much clearance you have, then judge from there.

Will going from a 12" rim to a 14" bring the sidewall of the tire up high enough to clear the tie rod end?

Sent while not working too hard

 

[zeebs]

Bumpity bump bump

Sent while not working too hard

 

[whoDEANie]

I have 28x11x12 and 28x12x12 zilla's on my grizz and have no rubbing issues at all. I would imagine you won't have any issues with 9" wide rubber, even with a 12" wheel. Besides, isn't that the same width of tire that comes with the machine?

 

[zeebs]

I have 28x11x12 and 28x12x12 zilla's on my grizz and have no rubbing issues at all. I would imagine you won't have any issues with 9" wide rubber, even with a 12" wheel. Besides, isn't that the same width of tire that comes with the machine?

Stock is 12" rims and an inch narrower front and rear.

Sent while not working too hard

 

[Rhodesie]

you should be fine with itp 14" wheels, the offset will be enough to distance the tire from the tie rod end. i don't think you can even get itp's with a stock offset. anyone around that you could borrow a front off of and try it to be sure?

 

[rzrgade]

You will be fine,bolt em up...........

 

[OnlyPolaris]

They will fit fine. Itp rims don't come in stock offset. They will basically be like adding a 1" spacer to the stock rim.