Rzr rear spindles grease fittings

[Tchetek]

So I needed to do the breaks, so I will tighten up any loose joints while I have things apart.

New wheel bearings are installed, and now tuning up some bushings at the A-arms to spindle connection. But these joints can only be greased by disassembly.

Has anyone tried drilling and tapping in grease fittings into the spindles?

 

[Tchetek]

Question: rzr spindle/bearing carrier maintenance.

 

[Tchetek]

Question: rzr spindle/bearing carrier maintenance.

???

 

[Tchetek]

No turning back now!

 

[Tchetek]

Yo mods!

My thread title could use a little tweak,

No more questions!


Kindly adjust: Rzr rear spindles grease fittings

Best Regards!

 

[arff]

Looks really good.

 

[QMAO]

I drilled, tapped and installed zerks earlier this spring also, the new bushings are tight enough that it is hard to get any grease in. After a few rides a coule zerks took grease. My theory is that if i know there is grease in there, there i no room for mud and water.

 

[Tchetek]

Drilled a couple hole through the pivot tubes to let the grease get inside the tubes to the bolts.

 

[Tchetek]

Still gotta pull off the wheel but don’t need to disassemble half the machine.