0neoldfart
Active VIP Member
Hey, can anyone tell me if the rear suspension from a 2012 Proclimb 162 will fit in a M-series? Need to know if mounting points and rail length are the same as a 09-11 M-series 162. Thanks.
Proclimb rails fit on M-series?
- Thread starter 0neoldfart
- Start date
MrHankey
Active VIP Member
Anything is possible with time and money, let me know how easy,hard it is cause that would be a slick mod
- Thread starter
- #3
0neoldfart
Active VIP Member
I know it can be MADE to fit, but I want to know if it is a bolt in and go setup. The only advantage to swapping out an existing skid to the proclimb is fancier rails near as I can tell - but I need a complete skid and have a proclimb skid available. Anyone?????
From the pics I have, looks like it might work, can't tell dimensions though, you would have to go to Ralph's and measure. Looks close, maybe front shock mounting on lower point is slightly ahead on the 2012? Can't tell from the pics, otherwise the geometry looks similar, I would think they would be close to fitting, the tunnel changed a little on the proclimbs I thought and this might mean the rear mount is slightly different? Unfortunately I don't have 2 sleds side by side. Should be close though, why not just switch the rails?
Captain Undies
Active member
Yes they will fit into each other. I did a track swap on my 1100t. I just put a 2.5 camo on my 2008 m1000 in april and then picked up my new 1100T this fall. I liked the 2.5 so i swapped the tracks on the sleds and when I did I put my suspension from the 1100t under my 2008 m1000 and it fit it with no jerking around. Now I didnt put it in and drive it but just to bolt in and see if it would work it sure did
Similar threads
