0neoldfart
Active VIP Member
Kicking around the idea of selling this machine... Wife requires knee replacement, so sledding days are pretty much over.
Sled is a 2013 Pro RMK 600 155 with 600 miles, has the following:
- Carl's Cycle 660 Big Bore: Pulls 62g Belly Buster weights at elevation, and has no problems with 800cc sleds - she went this route as she had doubts about the 800's reliability - these are truly a "pull and go" engine, no piggyback controller, has Carl's Cycle clutching as well
- C3 Belt drive with spare belt, geared down from stock, also has optional ratios
- Kmod rear suspension
- Kmod 37" front suspension with Evol R's
- Camoplast Challenger Extreme 2.5" track
- Fire and Ice Rear tunnel supports
- Fastrax front tunnel / bulkhead supports
- Polaris Extreme front and rear bumpers
- HPS can
- lightweight Ballistic Battery (sled has electric start)
- tether, tunnel and windshield bags
- skidplate
- not a scratch on the machine
Comments / opinions?
Sled is a 2013 Pro RMK 600 155 with 600 miles, has the following:
- Carl's Cycle 660 Big Bore: Pulls 62g Belly Buster weights at elevation, and has no problems with 800cc sleds - she went this route as she had doubts about the 800's reliability - these are truly a "pull and go" engine, no piggyback controller, has Carl's Cycle clutching as well
- C3 Belt drive with spare belt, geared down from stock, also has optional ratios
- Kmod rear suspension
- Kmod 37" front suspension with Evol R's
- Camoplast Challenger Extreme 2.5" track
- Fire and Ice Rear tunnel supports
- Fastrax front tunnel / bulkhead supports
- Polaris Extreme front and rear bumpers
- HPS can
- lightweight Ballistic Battery (sled has electric start)
- tether, tunnel and windshield bags
- skidplate
- not a scratch on the machine
Comments / opinions?