Nytro stalling

[Big A]

Hello all, new to the group here, looking for info from anyone with a supercharged Nytro. My MPI kit causes stalling if you get out of it too quick, wondering if it's just mine or a bigger issue. Also any other info on these setups as far as what works and what doesn't. I can tell you that the MBRP can works for heat disipation and power, however causes vibration at certain RPM's. Can also vouch for longtracking, went to a 162" x 3", huge difference with just apex rails.

 

[NM]

Do you have a good blow off valve on it. You are refering to when you chop the throttle right? Welcome.

 

[Big A]

I've heard mixed reviews on the blow off valves. Do you run one?

 

[NM]

I've heard mixed reviews on the blow off valves. Do you run one?

I run Turbo's but I can't imagine that sled would work good at all without a good blowoff valve. We need them for sure on the Turbo's. You could pick on up and install it in the charge tube...I bet it would make a world of difference.

 

[gotboost]

check your throttle cable for slack just seen this same prob on snowest website so go to snowest website under yamaha forum and take a look he had the same problem has u and if your cable has to much slack it activates yout tors for a slight second and that meens your engine goes to an idle for a mill second and that make it miss so i hope this helps u
l

 

[Big A]

That makes a lot of sense gotboost as the tors is stupid sensitive on the nytro, i'll be chekin that out tonight.