Need some help with these shims

[cat9]

first of all sled is a crossfire 700, I recently installed a used dd, and everything was good till I noticed my driven clutch "floats". I now realize I must have misplaced my shims that go between the dd and clutch. anyone know what size and how many of each I need? and where an I get them?

 

[DDrake]

You should be able to go online and find the info you r lookin for. Try Babbitts online. They have most makes and models and they have good exploded views of the parts they sell giving a person a pretty good idea the order of placement of parts during teardown or during installation. Hope this helps and good luck.

 

[cat9]

thanks, do I need to align the clutches after? cuz I don't got a tool, or know how to do it

 

[moyiesledhead]

Part #0648-443

You need either 3 or 4, don't remember for sure. Parts diagram only shows one though.

 

[cat9]

Part #0648-443

You need either 3 or 4, don't remember for sure. Parts diagram only shows one though.

good info thanks, is the clutch suppose to float at all on the shaft?

 

[cat9]

I found out the clutch isn't supposed to float, so should I just put enough shims/washers on to make it not float? or do I still need to check alignment?

 

[TROLLCAT]

I found out the clutch isn't supposed to float, so should I just put enough shims/washers on to make it not float? or do I still need to check alignment?

an alignment bar is cheaper than a belt or 2 or 3 , the shims set the alignment

 

[sled_wrangler]

A good cheap way to align them is get a piece of flat bar .. take the belt off put it between the secondary clutch plates and the middle of both clutched should line up center to center

Sent from my SGH-I337M using Tapatalk