need info on pure logic contoller settings for m1000

[jeffthebuilder]

Hello All-

I just purchased a used '07 m1000 with 162" track. It has D&D Y pipe, stock exaust pipe, and jaws silencer. It also has a pure logic fuel controller. Have not found a web site for the controller and need some help in initial settings....thanks!

 

[new24stroke]

Pureologic has it
on the web site

 

[Shredder]

Right here.

 

[sleliuk1]

Hello All-

I just purchased a used '07 m1000 with 162" track. It has D&D Y pipe, stock exaust pipe, and jaws silencer. It also has a pure logic fuel controller. Have not found a web site for the controller and need some help in initial settings....thanks!

I also have a pure logic box, and let me tell you the support for it sucks! I have an 08 1000 with the SLP pipe kit, vforce reeds, and the d and d firebreather intake. My settings are:

green-1
yellow-2
red-4
red blue-6-7

Also do not hook the white connector on the PL box up at all, leave the factory air temp plugged in on the 1000.

Your numbers will be a bit different because you dont have the pipe setup, so you will probably have to lean it out a bit, but if you check your plugs and piston wash after each adjustment you will be fine!

I have success with this setup so let me know what you think if you try these numbers. Hope this helps.

 

[markoo]

It's hard to give out numbers for a pure logic box. a 07 m1000 had about 3 different fuel map recalls. each map requires different numbers. each sled will vary in fuel pressure. each setup is different. If your running a y pipe and air box and can you almost don't need a box. set you numbers on the high side and work you way down until your plugs look good.

 

[sleliuk1]

It's hard to give out numbers for a pure logic box. a 07 m1000 had about 3 different fuel map recalls. each map requires different numbers. each sled will vary in fuel pressure. each setup is different. If your running a y pipe and air box and can you almost don't need a box. set you numbers on the high side and work you way down until your plugs look good.

yeah it is hard to give out numbers but its better to have something than nothing to start out with.