hnt4life
New member
Installed some linq brackets on my Matrys 165 from Canada Sled Parts perfect fit used the factory holes so no drilling was required nice and solid was able to reuse my BCA bag from my cat
Matryx linq brackets
- Thread starter hnt4life
- Start date
bjd68
Active VIP Member
Nice I was going to do the same. I have the same bag, could u have mounted it closer to the tank or did the factory holes not work that close ?
Nice!
Can you show a picture of the bottom of the tunnel? I'm wondering what the fasteners down there look like. The Polaris Lock+Ride bag I bought and installed on my Slash tunnel, just has big square (~1") head bolts that have a tendancy to turn when tightening them down.
Unfortunately with the L+R system I kind of have to run the bag right behind the seat, which would put my old LinQ 11l way back on the tunnel with these adapters, not sure I trust the tunnel's strength back there.
Can you show a picture of the bottom of the tunnel? I'm wondering what the fasteners down there look like. The Polaris Lock+Ride bag I bought and installed on my Slash tunnel, just has big square (~1") head bolts that have a tendancy to turn when tightening them down.
Unfortunately with the L+R system I kind of have to run the bag right behind the seat, which would put my old LinQ 11l way back on the tunnel with these adapters, not sure I trust the tunnel's strength back there.
Mountainman52
Active VIP Member
You should try bring less Pils up the hill.........
smc
Active member
the axys tunnel was rated for 7lbs and the matryx says 15lbs so wouldn’t worry about to much weight on the back. my buddies have cfr racks, carry two snowboards and a full QP bag of stuff, so probably about 40lbs in total, no issues yet
Similar threads
